20 Most Recent 1997 Plymouth Voyager - Page 6 Questions & Answers

You need to have a good shop put your van on a lift to find where.

Drivers side under dash, may be a black cover to remove for access.

Code 128 means the coolant temp is below normal range when the engine should be warmed up. Most common cause is a faulty thermostat.

Idk look for screws or clips remove and pull.

its either the fuel, spark plugs, or not enough air to complete the combustion cycle. Check the air filter to ascertain its not dirty. Check spark plug connections to ascertain there's a current from distributor cap to spark plugs when the starter motor turns. Spray starting fluid for half second before turning engine, and don't give throttle until engine starts, then increase throttle to 2,000 RPM. Once a month, pour a bottle of fuel injector cleaner to keep the injectors clear of debris buildup on the injectors' tips.

why the radiator ? any why how did this start was it running before has anything been done to the engine etc. has the battery been off... most problems with engine not starting is down to the immobiliser.. or a fuse blown in the engine bay. other problems can be the relays for the fuel and injectors these are in the engine bay. turn ignition on and tap the top of them if you hear a click then try to start engine and that is the one you need to replace.

sounds like you need to reset the catch. if that doesnt work, it could need a new door catch.

What's the problem? I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

its a bad head lite switch. repalace it

1. Disconnect the negative battery cable.
2. Drain the cooling system.
3. Remove the drive belts. Remove the timing belt covers and the timing belt.
4. Remove the water pump mounting bolts.
5. Separate the water pump from the water inlet pipe and remove the water pump.
6. Inspect the water pump and replace as necessary.

To install:

1. Clean all gasket and O-ring surfaces on the water pump and water pipe inlet tube.
2. Wet a new O-ring with water and install it on the water inlet pipe.
3. Install a new gasket on the water pump.

1. Install the pump inlet opening over the water pipe and press until the pipe is completely inserted into the pump housing.
2. Install the water pump-to-block mounting bolts and tighten to 20 ft. lbs.
3. Install the timing belt and timing belt covers. Install and adjust the drive belts.
4. Reconnect the negative battery cable. Fill the cooling system to the proper level with a 50 / 50 mixture of clean, ethylene glycol antifreeze and water.
5. Run the engine and check for leaks. Top off the coolant level, if necessary.

huh?

pour some water for sometime when the engine is running and you have to change the tension-er

under the hood

buy chilton manual form part store get airbags from u-pull-it junk yard

Loud clicking while turning, usually only in forward maneuvers.

YOU MY BE ABLE TO VISIT A DEALER AND DEAVTIVATE THE ALARM, THE 97 SHOULD NOT BE STOLEN, BUT THEN AGAIN I AM UNSURE IF IT EVEN HAS AN ALARM SYSTEM, OR IF IT DOES TAKE IT OUT.. GOOD LUCK

Try hitting the dash above the cluster a couple times with the key in the "run" position. It sounds silly buy is a technique I use to determine if the instrument cluster contacts have hairline cracks in the solder contacts.Before you replace the instrument cluster it'll have to be taken out and determine what color plug it has. Blue, black, white etc...

Which engine do you have?