20 Most Recent 2004 Chrysler Sebring - Page 9 Questions & Answers

If you mean clear codes, you can use a scan tool. If you need to reflash the computer to factory specs it would need to be done at a dealer or with an expensive dealer scan tool by some one experienced with the proper data.

Cams are WELL known for knocking on these engines. It isnt a sticky piston ring or timing. The cams have a wear point on the lobes and will make noise till warm and the oil is warm. I habe worked on many of these engines. Best bet is to run a good oil and a little heavier year around like 10w 30 high mileage oil. Even lucas oil additice helps with the noise because it doesnt drain down like oil and keeps the lodes and lifters oiled better.

had the same problem how that I fixed? had to buy the master window switch 2001 2004 Chrysler Sebring 4 Door Sedan Power Window Switch Front... Chrysler Sebring Power Window Switch AM Autoparts

there is a input and output speed sensor on the trans

if you have the 6cyl. engine, its on the side of the block near the alternator, just follow the radiator hose

search for cooling fan relay.

if this is under the hood (front of car), it could be an exhaust heat shield that is either corroded loose or a fastener has come loose. Does it happen when you rev the engine in park? if so, either have someone rev while you watch for whatever is rattling or have them watch while you rev.

The automatic idle control module is faulty.

sounds like only 1 of your 2 horns is working - up under hood near center in frt of radiator-or on 1 side down in front by wheel well horns are located

It is not all that hard, you can do it just get a haynes manual or any manual it will be very helpful and it away great to look at it when you doing the work. Have fun

More than likely a bad vacuum or electric actuator, or bad vacuum line. Actuators control the mode doors to change from floor, vent, and defrost.

The red cable ends must be connected to the positive post on both batteries. Hooked up wrong blows a fuse

If it is clicking if you turn the key,then starater motor gone bad..

Do I need to remove the front number to get to the horn. Chrysler Sebring convertible. 2008

Depends how good you are at it and if the nuts are seized. 60-90 minutes.

You have to remove the serpentine belt (takes a special tool) then remove the bolts holding the alternator to the engine block.