20 Most Recent
1996 Chrysler Concorde - Page 8 Questions & Answers
How do i get the ignition key switch out of 1996
Though not reccommended for a novice as major steering column damage may occur. I will give you basic (very basic!) instructions.
You will need the proper key. I'm not allowed to advise you how without the key.
Buy the new key and switch from your local auto parts store.
Remove the plastic moldings around the key via the various screws and clips remembering where they go. Once you've accessed the switch there is a black plastic clip around the switch I see in pictures that tells you the switch position, this should pop off as well. The switch will now be open. Locate the gold pin on either the bottom or rear of the switch. Insert the proper key and turn the key to run. Depress the gold pin. If the pin can not be pressed, turn to accessory and try again. While holding down the gold pin, pull outward on the key and the switch will come out of the column with the key. Notice the orientation that it comes out!!
Hold your new switch in the same orientation and place it's key in and turn to the same position you pulled out the old one (run or accessory). Begin to insert the switch, press the gold pin to click the switch completely back in and notice when it locks in place.
Test that the new switch turns back and fourth and starts the car. Replace your plastic moldings.
Congrats, you've just replaced your switch.
Keep your old key. It works your doors and trunk. Those will have to be rekey'd by a locksmith who has special tools and parts.
Best of luck.
DO NOT attempt unless 100% comfortable and at your own risk!!
How do i change the water pump on a 96 chrysler
Go to the autozone website at autozone.com and register your vehicle. It's free and you will have access to a full online repair manual for your vehicle. The steps and requirements for changing the water pump should be there. Hope this helped and best wishes.
Hard steering at a standstill
first check your tire pressures, or first check the fluid level for the power steering. either way check them both. If all is within specs then time to have it diagnosed at a shp. Also is the belt noisy. It could be slipping or a pully could have a frozon bearing
My 96 Chrysler Concorde turns but won't start. It
I had this same issue in my older bmw, it drove me crazy! not sure about your second question, but I replaced a CPS (crank/camshaft position sensor) and the TPS (throttle position sensor) all around 50 bucks each, and it started up fine and runs!
Hope this helps!
How can I reset the service engine light
disconnect the positive terminal of the battery for 2 minutes then put it back it should clear it
but if the computer detects a problem it will come back on and you should have it put on a computer diagnostic machine to correct the fault codes
90 Ford F150 Headlight adjustment and heater door
The heater problem could be a vacuum issue. My 89 has vacuum operated acutators, so if you had all of that out, all the vacuum connections for the heater box and controls may not be connected correctly. I would check those first. The actual door is a flapper door inside the heater box up under the dash, probably center or slightly right of center. Follow all the ducts and where all of those go into the heater box is where the door is inside.
For the headlights, I like to adjust mine on a flat dark road. It is difficult to adjust them againist the side of a wall. If your truck suffered front end damage, there is a chance your core support is bent backwards which would affect the adjustment range of your headlights.
There are actual headlight aiming machines, and you could pay to have yours done, but I have had really good luck as well as getting them even when its dark and you can see whats going on and what kind of pattern the lights are shining.
Hi i have a 1994
5/16 flaired ends with farrels onboth ends or in rare cases 4.75 metric vs 5/16
Not finding what you are looking for?