20 Most Recent
1995 Chrysler Concorde - Page 8 Questions & Answers
Heater on 1995 Chrysler Concorde stopped heating.
there are no reset codes, did you bleed the air out of the cooling system? if not do this procedure, if that doeasn't fix it u have a failed air temperasture control blend door motor actuator.
The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, then fill the coolant recovery tank full and run the engine until it just starts to overheat, high end of normal zone on gauge, then shut the engine down and run cold water over the radiator core, this will self bleed the system and the coolant will be pulled from the recovery tank, repeat as necessary, never let the recovery tank run dry or more air will be pulled into the cooling systeml ,
Won't start sometimes.
Hello. You have a short in your ignition system which causes all of these problems. Look in the yellow pages of the phone book or on the computer for an autoelectric shop in your area. These shops have the diagnostic tools to find these shorts and repair them. Regards, Joe
Overheating
I'am not shure from your post if you changed the radiator and water pump as an attempt to fix the problem or if it started to overheat after the work was done? Either way, try a new thermostat.
ABS light is on in my car
Hi. this alert is to notify you of a fault within the ABS sensor module(sending unit). This will require the attention of a service tech. They will simply replace the bad sensor with a new one and the warning light will go off. Most of the time, a hard brake during travel will trigger the ABS system. If the sensor is malfunctioning during this time, the light will stay on until you get it replaced.
please rate and god bless.
On a 1995 Chrysler Concorde it is trying to start
was the battery charged prior to replacing alt if it wasn't battery possible still to low/weak to start vehicle alt charges battery and also runs accessories / battery starts vehicle if it wasnt charged vehicle wont start if battery is charged check conections for loose or damaged
Door handle came completly off of door frame and
Remove the lining from inside the door and expose the inside of the door. For this you will have to remove the latch, and all the screws that you can see. be careful not to force on anything. If the lining is not coming off then there may be some more screws holding it.
Not finding what you are looking for?