20 Most Recent 1995 Chrysler Concorde - Page 7 Questions & Answers


The hasard flaser swith on the dash has the flasher in it. Many times the turn signals don't work either as it does that too. If they don't work any of the time., a fuse or turn signal switch problem may be happening.

1995 Chrysler... | Answered on May 21, 2010


under dash ,,on top of steering colum at the bottom,

1995 Chrysler... | Answered on Apr 28, 2010


no such thing as to muck vacuum. its impossible. check for bad pcv vavle. a coating of oil inside manifold is normal

1995 Chrysler... | Answered on Apr 27, 2010


assuming the battery is good.
It will probably be the solenoid on the starter, you will have to remove the starter and repair or replace.
If it is a continuing problem it can help to fit another relay opperating off the start wire , the relay is fed from the battery, and then feeds the solenoid, this way maximum voltage is applied to the solenoid and it will work better

1995 Chrysler... | Answered on Apr 26, 2010


There is an ASD relay and a fuel pump relay in the underhood fuse box that could be the problem.. Rotate with the ABS and the horn to see if it will now start. If that doesn't do it then you have a crank sensor and an ignition module. that can be the problem is you have no spark. The crank sensor is usually the culprit and it can be tested using a graphing meter. You need to watch the waveform for consistency

I bet you wish now you had it diagnosed properly. You would of saved yourself a couple hundred dollors at least and hours of labor.

Remember tho that I am not saying what I'm suggesting is the problem. Its also possible your computer failed. Without testing its all just a guess

1995 Chrysler... | Answered on Apr 16, 2010


If the injectors are OEM for that motor then it sounds like your idle got knocked off or was adjusted to compensate for the old injectors getting worn and clogged. Look for you throttle cable at the intake manifold. Where the swivle is for the cable there is an adjustment for the cable. It should be a little round nut or screw.

1995 Chrysler... | Answered on Apr 10, 2010


In most cars, it is placed in the same chamber as the intake air filter. In my 96 corolla, it is on the "clean air" side of the filter box just before the pipe that leads to the manifold. The only thing i can think to compare the apperence of the sensor to would be something like a small rubber spark plug. If it is not in the air filter box, it has to be somewhere attached to the manifold or the pipe leading from the manifold to the air filter box. Let me know if this answers your question and rate my response please.

1995 Chrysler... | Answered on Apr 09, 2010


it is bad wireing or badly connected or burned fuse
start with the fuse
look in the car manual, which fuse you should replace

good luck

1995 Chrysler... | Answered on Apr 07, 2010


Could be brakes pads/shoes are worn out, brake drum/rotor grinding from metal to metal contact. Or a bad brake caliper. Parking brake could be on. Or rear wheel bearings.

1995 Chrysler... | Answered on Apr 02, 2010


put a bottle of rubbing alcohol in the tank - and change the fuel filter

1995 Chrysler... | Answered on Apr 01, 2010


the "positive electrical whatever" you mentioned is probably the positive battery terminal. does the car have an amplified stereo system? if so, there is most likely a broken wire at the positive terminal, preventing the amplifier from powering up and playing the music.

1995 Chrysler... | Answered on Mar 30, 2010


My sincere apologies for the delayed response.
I have only been a free contributor to this site for the last 4-months.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, however I am answering it either way.

Click on the following direct Link. It has several Diagrams you will need for your Timing Belt replacement. Included are the Cover Bolt Locations, Tool Needed and Marks for your specific engine.
You may also want to Print out these Diagrams for future use.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Again my apologies...

http://www.2carpros.com/car_repair_information/year/1995/make/chrysler/model/concorde/1995_chrysler_concorde_timing_belt_diagram_marks.htm

1995 Chrysler... | Answered on Mar 18, 2010


hot wire cant be said on the net. so it could be the fuse is bad so change the fuse. so try going to your mechanic to help pop it open

1995 Chrysler... | Answered on Mar 17, 2010


this engine doesn't use a timing belt it has a timing charin, they are designed to last the life of the engine and have no set change interval.

1995 Chrysler... | Answered on Mar 02, 2010


12 Direct battery input to PCM was disconnected within the last 50 key-on cycles 55 End of error messagesThose are codes too,see above.

1995 Chrysler... | Answered on Feb 21, 2010


how do i install a new ignition switch on my 95 chrys conc

1995 Chrysler... | Answered on Feb 19, 2010


You will find the connector near the steering column, attached above or very near to the panels under the dash. It is rectangular.

1995 Chrysler... | Answered on Jan 30, 2010


Disconnect the negative battery terminal to see if the system will reset.If it still will not fire,the module in the computer may be burned out,replace the e c m,the computer.

1995 Chrysler... | Answered on Jan 16, 2010

Not finding what you are looking for?
1995 Chrysler Concorde Logo

292 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Concorde Chrysler

  • Concorde Chrysler

Most Popular Question

1995 chrysler concorde wont start

  • Cars & Trucks
Loading...