20 Most Recent
2004 Subaru Forester Questions & Answers
I have an 98 subaru
Hi,if you are talking about the harf-shaft,try putting the car on axle stand and turn the wheel by hand see if the shaft spins strait,hope this was some help,hope you sort it.
I have just purchased a 2004xt Forester when i
Could be several souces:
1. Check the alternator and AC belt idler bearings. Replace as needed.
2. Check the alternator itself for noise and bearing wear. Replace the belt if needed.
3. If very cold (below 0C) the power steering pump make a lot of noise for a while (30s to 2 mins) till it all warms up.
4. If the above are OK, then the next is the timing belt idler bearings.
I have a 2001 Subaru
You have a loose belt on the A/C. On most new cars that is one big belt that drives everything on the car. If when you look at the belt on the grooved side, do you see cracks on the grooved part running across (from side to side) on the belt? if so, it is in bad need of a new belt. A new belt should stop the squealing noise. While you are replacing the belt also check the belt tensioner to ensure it is in good working order.
Where is the inertia switch reset
It depends on the error code(s) being reported. A very common one (P0457) is that the engine computer thinks the gas cap is loose. The gas filler neck often develops rust holes which cause this code, fix is repair usually quite easy, or replace. There are many other error codes. Look around your area for a Subaru shop other than the dealer. Your problem fix may much simpler and cheaper than the dealer, who often give the most expensive, worst case, repair options.
Not finding what you are looking for?