1999 Chrysler Town & Country - Answered Questions & Fixed issues
1999 Town and Country: door
Get a wiring diagram. Unplug connector from BCM and do a continuity check on each door at the BCM. That'll tell you whether it's a door switch, wiring or BCM problem
A chattering noise appears when I put the transmission in gear
Hi,
Sounds like a worn/bad/damage transmisison or engine mount. These hold the engine and trans in place and usually have a rubber part that can wear out.
Either a trans shop or regular mechanic will need to diagnose.
I don't know the cost.
GL,
TD
How to erase error codes
You might be able to disconnect the negative battery cable for a period of time?
Otherwise, the use of an OBD II, Scanner/Reader should be able to clear codes. Most Auto Parts stores will provide scan-read-clear services for free.
Multable problems
It happened to our 99 too, turned out to be inside the steering wheel. a coil that Chrysler recalled. It was a free repair at a dealership
Why my van wont crank with oil light on
This can be a safety feature the manufacturer has implemented in this vehicle. Make sure the oil level is full. Is the vehicle ,making any tapping noises from the top end? ( valve train noise) If oil level is ok, you may have a defective oil pressure switch causing your symptoms. If the engine is abnormaly noisey it is possible there is no oil pressure and further diagnostics will be requred
Why are my low beams not working?
There is a relay for the Head lights in power center near battery in the engine compartment. Swap out a working relay and see if it fixes it. Replace with a good relay .!. Good Luck!
Not finding what you are looking for?