20 Most Recent 2005 Mercury Sable - Page 9 Questions & Answers

Check the switch on the brake pedal lever. The drivers feet can bump this out of position.

1st have the brake pads checked, then if the pads are OK you likely have a defective wheel bearing/hub assembly

there is still air in the system. To bleed the brakes bleed out the m/cyl first by loosing off the lines at the cylinder v/ This primes the master cylinder first. Then starting at the longest line first bleed out the air finishing at the shortest line

The mechanism is located behind the plastic trim panel that covers the pillar. You'll have to remove a couple of screws to get it loose.

have a pressure test done on the fuel manifold to check for pump-regulator pressure and filter performance. You state that the filter was last changed in 2007 so it is well past it's blocked up date .. Run fault codes . replace the canister . Have a compression test done as the engine is getting long in the tooth and may need refreshing .. Check that the cat converter is still operational as they will block up the exhaust system and cause poor performance

on ford cars there is a tool that u can find in any auto part to remove the fuel filter

If both heater hoses are getting hot, it could be a blend door problem under the dash.

it could be a vacuum line from tranny to motor might need put back on with a clap

check fuses -replace if blown check 4 way/hazard - testing bulbs & relay at the same time check turn signal relay - replace if broken check wiring for defects - it does happen

horn is bad or not connected more than likely

Hello, One of the sites that has fuse and wiring info is Autozone. They ask you to register(free) and then allow you to look up a limited number of cars for info. You will need to go to the bottom of the Webpage in the Help section. You will need to Navigate your way through free and pay sections. The info you need is in the free section. When you get the info you can see what those fuses apply to. Yes rewiring can cause issues. Have your battery checked for performance. A starter "draw" test and the battery test is done free at Autozone, Advance, or Oreilys. When you have issues with the Anti-theft, it can reduce power to the starter. Sometimes a shorting battery can trigger the antitheft. There are many unused fuse slots in a vehicle. Besides options, the fuse blocks are made for universal fit to save money. Every circuit needs protection. The protection has to be the same Amp fuse or wires will burn or fuses will break. What you may also wish to do is restate the problem and include the "missing issues" that you did not include the first time. It might provide a clue for us to solve your problem.

If there is no "check engine" light, you may have a faulty MAF sensor. If you need further help, reach me via phone at https://www.6ya.com/expert/david_f2436a37cbb50365

Check your Inertia switch. It would be behind the front kick panels or inside the trunk. It has a reset button. Check the Web for photos of what your part looks like. This part is an emergency disconnect for the fuel pump power.

try this.. turn off the heater and let the car idle.. wait until the fan comes on.. if it does not come on before the guage pegs over extremely hot(you will smell antifreeze) then you have a water pump issue and/ or thermostat/ cooling fan relay issue.. if it does come on and cool down..use this as a base reading for this car as long as everything works fine..

Are the lenses clear or are they yellowed? They make kits to clean the lenses (headlight covers) Compare your headlights to a new car - you should see the difference.

while holding the door handle up to open try to separate the fingers in the door latch if they wont separate.. the rods inside the door may have broken loose from the mechanism..this requires removal of the inner door panel to look at..

battery is not taking charge, replace battery

You will need to remove the steering column cover to gain access to the mounting bolts. Use care in unsnapping the wiring connectors. You might try pushing the Emergency flasher button if it is on the switch. The contacts in this design use the same part for the turn signals and can be misaligned through use. Pushing the Eflasher 10-15 times make shake the contacts back into position.

Is that the over flo tube,?

i have no turn signals on my 1998 mercury sable