Top 20 2000 Mercury Villager Questions & Answers

How is it spewing but not leaking ?

There isn't one. Cruise Control is a joint computer operation by the BCM and ECM.

Mercury Villager (1999-2002) fuses and relays

Fuse Box Diagrams https://fuse-box.info > mercury > mercury-villager-19... Here you will find fuse box diagrams of Mercury Villager 1999, 2000, 2001 and 2002, get information about the location of the fuse panels inside the car, ... https://www.google.com/search?q=mobile+auto+electrician+near+me ..

I'm assuming it's a fuel injected engine. If so, and you can't see an in-line filter after tracing the lines, it's probably in the fuel tank. If the fuel supply, return, and vent hoses go to the top of the tank, pull the carpeting or back seat, whichever is above the tank, and look for a screw down plate. When you remove the plate, it will give you access to the housing for those items.

Ford Firing Order Archives Ricks Free Auto Repair Advice

its the distributor.

easiest way to test the coil is to put a hose about 3-4 inches long on coil then put spark plug in other side of the hose and have a helper turn the key. look for a blue spark at the plug. if no spark then that side of the coil is bad.

These EATC fault codes are commonly caused by a sticking air temperature control blend door and or the blend door actuator..

Don't take chances with brake issues. All anyone here can do is guess what the problem might be. Get it to a dealer or a reputable mechanic - have it towed if you're afraid to drive it - and have it diagnosed and repaired.

Try 2000 mercury villager knock sensor location Google Search

You will need to have the dealer program a new key.

I, feel sorry for you, after reading your problem, but don't worry you visit the Reliable-Store they will help you for sure. Best Manuals

Check all fuses,If switches for other doors work, test and replace driver multi switch if defective. Switch OK, you will have to check wires for damage at hinge area of door by removing protective sleeve, if wires are damage, make repairs.

A burning smell is an important symptom of something VERY WRONG. Get it towed to a repair shop, and get them to trace the wiring harness.

Refer to your owners manual under the maintenance section.

Have the filter inside the transmission changed. If that doesn't solve the problem then the clutch plates have worn too much or the front pump is not supplying the correct fluid pressures. That would need a complete rebuild to fix.

Typically caused by anti-pollution message re Oxygen sensor or Engine Coolant Temperature sensor.

Undo the hose clips at each of the hose and replace it , fit new hose clips to each end.

What resistor ? there a few different one's .

P1705--Transmission Range Sensor out of self test TYPE: 2000 Mercury Villager OBD P1705 and read up

The knock sensor is located under the intake manifold. Not an easy job to change without some experience.