20 Most Recent
2000 Mercury Villager - Page 2 Questions & Answers
Wiper fluid level sensor replacement
Reservoir —Windshield Wiper
Removal
- Remove the RH wheel; refer to Section 204-04 .
- Position RH splash shield aside.
- Remove six screws.
- Remove three pin-type retainers.
- Position RH splash shield aside.
-
NOTE: Windshield washer fluid should be collected in a container after the windshield washer hoses are disconnected.
Disconnect the electrical connector and washer hoses.
- Remove the upper reservoir bolt.
- Remove the windshield washer reservoir.
- Loosen the two lower reservoir bolts.
------------------------------------------------------------------------------------
I just broke the housing
Bad news, this part isn't "fixable"; just look it up at autoparts, looks pretty easy.
Also,you can find what you need at your local junkyard.
Fig. Thermostat water inlet sealant application and exploed view.
Hope this helps.
Knock sensors location
The knock sensor is located under the intake manifold. Not an easy job to change without some experience.
Code P01705
P1705--Transmission Range Sensor out of self test
TYPE: 2000 Mercury Villager OBD P1705
and read up
2000 mercury villager problem P0325
Hi Valerie, I'm glad to help!
P0325 is a Knock Sensor or Wiring issue. The best way to know for sure if its in the wiring or computer issue is to first simple replace the "KNOCK SENSOR". Hope this helps and have an awesome day Valerie.
Knock sensor location
The knock sensor is under the intake manifold. Please be advised the sensor very seldom fails.
Ignition key wont turn
If you have tried another key, and there is no force restricting the lock, the lock cylinder may have jammed.
Rear seat removal 2000 merc Villager
fold top seat down first
then there is seat clip push seat forward with upward motion
this releases back floor clamps once released pull seat back this releases the front clamps then pull seat out of back door
My van's doors keep locking by themselves
either you have water in the door lock actuator connecotrs in one of the doors. or a misadjusted lock rod for the inside lock switch or a wire shorting out in one of the doors (for the lock actuator).
This was an issue for earlier models through 1997. If no luck with those, you will have to cut a wire in the driver door lock actuator harness that will eliminate you being able to lock or unlock all doors at once with the key in hte driver door lock cylindr.
go here for Villager help.
http://autos.groups.yahoo.com/group/villagerquest/
Look in the photos and files and ask questions via email. we will help you.
Diagram camshaft sensor
I am not sure where it is located on your car but if u go to auto parts store they can show you the drawing where it is located
Not finding what you are looking for?