2000 Lexus ES 300 - Answered Questions & Fixed issues
We replaced battery in key fob for 2003 lexus
I will help you I have been there before what you're going to have to do is program the key for the entire car and you can do that by following instructions on YouTube or you can call the dealership and I'll give you instructions for free
Headlight wiring 2000 Lexus ES300
if the vehicle was not designed for hids its best to make a relay system off the original head light wiring, like you would do for fog/spotlights this would draw power direct from the battery and not the original wiring as the original wiring may not be able to take the drain from the startup of the hids. there are kits for vehicles so no wire cutting is involved, just plugs into the original wiring. same with led kits. https://www.hidextra.com/lexus-es300-hid-kits/
Error code that says lean fuel. Injectors were
Yes the airflow meter is very easy, it is in the air intake hose to the engine from the air cleaner. Boy those Japanese car makers really take you to the cleaners on repairs, that repair on a GM car would have been 1/2 that amount.
Installation of the Lexus ES300 muffler consists
the bolt goes through the both flanges and the springs go against the last flange and under the nut of the bolt
it is a system that allows movement between the couplings so that the system doesn't crack from fatigue due to engine/ , pipe movement
I have a 2000 Lexus ES 300. I purchased it as a
Hi, have a good look on web, I was told similar over the top cost for ford focus, looked at web, and on that vehicle, insert key, turn on (till ign lights show, DO NOT START, turn back one click, then back to ign lights show AGAIN NOT STATRING, on board computer reprograms key.
That worked for me.
How do i change the oil pump on a 2000 lexus es300
Drain oil from the oil pan and recycle. Remove bolts holding oil pan up and remove oil pan. Remove bolt holding oil pump in. Install new pump. Replace oil pan gasket if necessary. Reinstall oil pan. Reinstall drain plug and refill with oil. Start engine and watch oil pressure gauge or light. Oil pressure should be normal almost instantly. Check for oil leaks.
Hello How Do I get the emergency brake to release ?
There may be a parking brake adjuster, loosen it off, see if it helps? Next, get at the rear brake assembly, if there is a star adjuster loosen it off, hopefully, that will loosen the brake pads? At the rear brake assembly, maybe you can get at the parking brake cable?
I can't see anything from here.
Safety is your responsibility, if you get brakes released, you need to make sure brakes work properly before driving, again.
O/d will not work after a stop; unless you turn key off and wait 2 min.
Check codes. More than likely you will come up with the shift solenoid. This commonly effects the o/d and the transmission seems like it wont shift. It is just not receiving the right signal from the computer when its time to shift. When taking off from a stop try this, once you stop put the car in "low" when you take off, slowly shift into 2nd, somewhere near 1800 rpm and 2000 you will shift into drive. Car may jerk since it needs to be precise. But if you do not have this same problem when manually shifting the car like this, then most likely it is the shift solenoid. I am not sure about your year but I do believe you have to drop the trans pan to change this solenoid. By the way, you put the gear in low at take off because low is not connected to the computer. So you are tricking it.
Not finding what you are looking for?