20 Most Recent 1996 Jeep Grand Cherokee - Page 9 Questions & Answers

your rear wiper motor might be faulty,in the front i would check your fluid level-if it is full and you hear the pump running-check your washer lines to see if they are pinched-usually around where the hood closes

1996 Jeep Grand... | Answered on Apr 21, 2015

you can't

why not watch the youtube of a guy doing just that
watch that first.
then ask.

what and amazing question , never ever seen it in 10 years.

google it or read the book
I have all 5 books, there are not that many
bought at Barnes and Noble, so can you
or google ,ever do that, in plain english a question
1st hit.

1996 Jeep Grand... | Answered on Apr 18, 2015

You have a Power or Ground Problem somewhere! Power/Ground not getting connection to the Battery or the Ground isn't getting connection to the body/frame!

1996 Jeep Grand... | Answered on Apr 17, 2015

Hey John how's it going ? First you need to see if there is battery voltage on the dark green an orange wire at the coil ! Do you have a DVOM - digital volt ohm meter ? You can buy one for $10.00 ! Or you could use a test light ! If you have no battery + voltage more then likely you have a bad ASD relay ! Now on the other side of thing's if there is battery voltage you need to see if the PCM is turning it off an on ! This is a white wire at the coil , a test light would work best here . Hook up the clip end to battery positive an the point end hold on the white wire connector end an have someone crank over the engine , the test light should flicker . This indicates the PCM is controlling the coil on an off ! Now if there is no control , more then likely you have a bad crankshaft position sensor ! No Spark Testing control testing

1996 Jeep Grand... | Answered on Apr 11, 2015

The rattle is likely a loose shield or a bad catalytic converter. As for the loud banging, Have you checked the front U-joints behind the brake rotors. As for the Reverse noise? Auto or stick shift?

1996 Jeep Grand... | Answered on Apr 08, 2015

The fuel pump only turns on for 2sec when key is turned on for a fuel pump prime. The fuel pump will turn back on during engine cranking. The most likely cause of stalling on this particular vehicle is a weak/bad crank sensor.

1996 Jeep Grand... | Answered on Apr 06, 2015

This one is tricky. Any check engine lights. Could be O2 sensor. How are your vacuum lines this could be a leak issue from a worn hose. Possibly your ignition coil. Could be getting weak. I need more information

1996 Jeep Grand... | Answered on Mar 31, 2015

sways at what speeds.?
with side winds or not.?
loaded car or unload, trailer?
sway as in body tilt , left to right.
or diving?
answer like a pilot.?
roll , pitch , yaw..?
are wheel bearing tight.?
are tie rods? tight.
ball joints tight, there are tests for each,
shock good (dampeners)
get a suspension shop check it for near nuttn? do so. saves time and money and safety issues.
they will find it fast, (tell em' diagnosis only")

1996 Jeep Grand... | Answered on Mar 23, 2015

this is USA English site. please post in english.

1996 Jeep Grand... | Answered on Mar 18, 2015

The crankshaft position sensor frequently shorts on these jeeps. Try unplugging it and see if it cjamges anything

1996 Jeep Grand... | Answered on Mar 15, 2015

wiring fault get an auto electrician to trace fault

1996 Jeep Grand... | Answered on Mar 13, 2015

in the gas tank
but there is not such a part on a 95

why not say where you saw this.?
1: on my car (show a photo) please.
2: on the dash. cluster.?
3: on my scan tool.?
4: heard in on grape vine (net rumors endless)?

on newer cars some have this in the tank.

1996 Jeep Grand... | Answered on Mar 12, 2015

it has a small wiper on it on right side maybe or in middle by windows

1996 Jeep Grand... | Answered on Mar 12, 2015

I would suggest that the answer is in the fault codes as you have not replaced any ECM control sensors that will be the cause of the problem

1996 Jeep Grand... | Answered on Mar 11, 2015

The computer is very easy to replace. Its located on the passenger side of the fire wall. I believe 4 screws hold it on. Unplug the connectors, remove the screws and thats it. Most junkyards will have your part for around 80 bucks. Hope this helps

1996 Jeep Grand... | Answered on Mar 10, 2015

seems like Air cleaner, remove clips (trip them and look yet)
first off they they have like 4 engines, opted, 2 in USA
why not post what is there.
in fact that is first thing any mech does,
ID the engine, 4.0L or 5.2L or 2.5 TDI
all answers USA cars , on this USA forum. the ZJ
ill pretend 4.0L inline 6 engine, 5million sold.

the full drawing on engine are on the jeep.com dealer page.
ever seen that.
here it is.

here it is, just look and find all parts on car, heck any car you can do that, at your makers brand.com


1996 Jeep Grand... | Answered on Mar 06, 2015

Here you go, pick the one that applies:


1996 Jeep Grand... | Answered on Mar 03, 2015

Try and get code when lite comes on , but I had a similar problem and cylinder coils we're going bad. Take it to a jeep dealer and they'll fix it or try and find out which coil

1996 Jeep Grand... | Answered on Mar 02, 2015

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

4,547 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts


Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Grand Cherokee Jeep

  • Grand Cherokee Jeep

Most Popular Question

starting problems

  • Cars & Trucks