Top 20
2000 Chrysler LHS Questions & Answers
2000 chrysler lhs wheels/tires leaking air
I have seen complaints about the factory chrome peeling off in the bead area and causing leak. Didn't find a service bulletin for that.
Take it to a tire shop let them look at it, see if they can smooth up the bead area. It would only be in the bead area. In the past, I have used a wire brush adapter that fits in a drill to clean rust off the rim bead area. I don't know if that would work, if chrome was peeling.
As a last resort, replace the rim. I don't think Chrysler is going to help you?
Heat TEMP and blower problem.
Your blend doors are not working properly. There is small electric motors that move them. Shouldn't be really expensive to have fixed.
Why doesn't it start?
sounds like a cathletec converter stoped up take o2 sensor out beforethe cat and see if it is better if so replace cat
Car has been sitting Need to run.
The old gas will cause hard starting for sure as it is 15 years old but if you don't have very much in the tank you can mix in some new gas.
Where is trunk fuse located?
Should be able to refer to the Owners manual for a diagram that details all of your fuses and relays. I don't remember specifically which fuse it is but I've replaced it before using the owners manual.
How do I change the flasher fuses
Flashers have no fuses.. they are either electronic or thermoelectric in their operation. They either work or fail completely. If they don't work you unplug them and plug in another one.. The clicking sound is to alert you to their working and remind you the lights are blinking
I have a 2000 Chrysler LHS with the 3.5 engine.
Hello Lia, you did all the right things to fix it but there is some thing elise going on ,if your sure that ,thermostat is not in back wards and its not defective (they do get stuck )and fans are running on time the only thing left is the start of a head gasket ,eaven thoe coolant is clear and no coolant in oil, .did you purge all air out of motor, (no joke) you'll see 2 air purge valves on top of motor ,they look like brake bleeder valves,one on right side and one on left side traped air will cause over heating as well.
I really hope this helped you in some way .
Woody
Not finding what you are looking for?