20 Most Recent
2002 Jeep Wrangler - Page 9 Questions & Answers
AC Condenser replacement
Best to use flair nut wrenches wherever possible. On free standing lines always use a backup wrench to avoid twisting the line and breaking it. Doing the R&R isn't terribly difficult but you need an evacuation pump to check your work for leaks and to remove air in the system before re-charging. If you don't have one, consider having a reputable shop do the work.
I believe chilton or haynes makes a separate AC manual. If you can get one it will be helpful to ensure your diagnosis and procedures are correct.Otherwise it's the same job as doing a radiator, but one step further in.
Good luck with it!!
4/5/2010 5:13:27 PM •
2002 Jeep...
•
Answered
on Apr 05, 2010
It blows the fuse everytime I put the cell phone
most of the time its the cell phone charger that is the problem. the ones with the cheap plug that has the fuse inside it are the worst. try the lighter in it, if it works without blowing the fuse then you should get a new charger or replace the plug with a good one
3/30/2010 12:15:47 AM •
2002 Jeep...
•
Answered
on Mar 30, 2010
Air vent selection not working correctly.
ok there are three places to look! first open hood one the drivers side look at the intake manifold and see if theres a loose vacuum hose if so connect it to the port! second passenger side look on the floor twoards the dash in the center the are vac lines there same goes for the drivers side near gas pedal
3/18/2010 1:39:00 AM •
2002 Jeep...
•
Answered
on Mar 18, 2010
My 2002 jeep wrangler has a battery drain that
When you remove the accessory fuse -- you have to note what cicuits have turned off. Then one by one start isolating the circuits in that fuse system. Obviously there is a short in one of them-- eg. cabin light , trunck / hood light or dash cloak. On the light you may just have a bulb shorting out.
You have done good so far by locating the fuse-- you are not far off from fixing it!!
Good Luck.
3/3/2010 5:32:38 AM •
2002 Jeep...
•
Answered
on Mar 03, 2010
My 2002 jeep wrangler check gauges light came on
With the jeep running put a volt meter on the battery and it should be reading above 13 volts if not replace the altinator it isn't charging.You can check the fuse for the altinator first if not charging but most likely the altinator is bad.
1/31/2010 5:15:30 PM •
2002 Jeep...
•
Answered
on Jan 31, 2010
2001 jeep wrangler oil pressure sensor switch
Use an extractor designed for removing broken pipe fittings and broken bolts. They're often called bolt extractors and are available from tool merchandisers. Sears probably sells them as well as auto parts stores.
1/14/2010 3:50:06 AM •
2002 Jeep...
•
Answered
on Jan 14, 2010
Hi!
There are two bolts way up on the bellhouseing near the head connecting to the engine. You should have at least 4 bolts from the block alone, along with others.
1/8/2010 8:01:15 AM •
2002 Jeep...
•
Answered
on Jan 08, 2010
I have a 2002 jeep wrangler x model. what holds
mounts hold the tranny in place also its bolted to the motor,skid plates are only to protect from damage if you were to go off road with it.the skid plate can be removed and disposed of if you wanted its useless if you dont do the off road people like them for show as well i have all chromed out skid plates on mine
12/23/2009 4:16:25 AM •
2002 Jeep...
•
Answered
on Dec 23, 2009
Freeze Plug. How difficult to replace?
It depends which one will need to be replaced. Plugs just dont go bad, if its rusted out, its because just water or weak antifreeze has been in the engine and they will all need to be replaced, sooner or later. You need to flush the cooling system, replace any hoses that feel crunchy or soft and I would recommend brass plugs if you can get them. The water pump may have damage from the vanes rusting. and the radiator blocked up with rust. When you get the old plug out, you can guess the condition of the others by the back of the plug.
12/15/2009 1:46:19 AM •
2002 Jeep...
•
Answered
on Dec 15, 2009
Not finding what you are looking for?