20 Most Recent
2002 Jeep Wrangler - Page 6 Questions & Answers
It jumps out of first gear or will not stay in
Your trans has a mechanical problem. Could be a couple of reason for jumping out of gear, but it will have to be removed from the vehilcel and tore down no matter what is causing the issue. Sorry for the bad news.
8/8/2011 8:35:10 PM •
2002 Jeep...
•
Answered
on Aug 08, 2011
Sport Wrangler 6 cyl. Engine
Check the plugs, wires and coil pack for these two cylinders. Most lilkely it is the coil pack, they work for 2 cyclinders at a time. cylinder motors use 3 and 8 cyl moters use 4 of these. If your und=sure where the coil pack is, follow it backwards from the spark plugs.
7/8/2011 3:20:10 AM •
2002 Jeep...
•
Answered
on Jul 08, 2011
Hi, I have a 2002
I assume you must have also checked the rear turn signal bulbs.
You may have to start using a volt meter. Check for 12 v at the bulbs also check the bulb ground...that's a common cause of light problems.
6/29/2011 6:49:06 PM •
2002 Jeep...
•
Answered
on Jun 29, 2011
I have an 02 wrangler and the oil preasure goes
First we would need to know when this occurs.
Asuming the oil level is at the full mark!. If the pressure goes up
during acceleration and down at idle when engine is fully warmed up,
then this is normal. An engine requires 10 psi of oil pressure per
1,000 rpm ( ex. 20 psi at 2,000 rpm, 25 psi at 2,500 rpm, and so on )
. If the gauge is moving back and forth erratically at idle , i would
say the gauge is bad. If it drops to 0 while accelerating I would say
your oil pump is bad. If from time to time it seems to work and other
times it seems not to work, I would say the oil pressure sending unit for the gauge is bad.
If the pump failed you would start to here a
Knocking noise from the engine in a short period of time. Use the
above scenario's to narrow down what it may be.
6/7/2011 5:15:28 PM •
2002 Jeep...
•
Answered
on Jun 07, 2011
Check engine light came on...
there is no code P0503, so you need to double check what the code is, or get a code reader. you cant clear it without a scan tool. if you disconnect the battery it may clear, but its not a good idea, as you will lose any freeze frame data which would help a mechanic diagnose the problem.
4/23/2011 11:35:21 PM •
2002 Jeep...
•
Answered
on Apr 23, 2011
Anyone know where the engine number is on a jeep
2002 Jeep Wrangler 4WD 2.5L SFI 4cylFig. The engine serial number is located at the right front side of the engine block (models 1997-2005)
I hope help you wth this; good luck (remember rated this help).
4/19/2011 2:56:03 AM •
2002 Jeep...
•
Answered
on Apr 19, 2011
2002 jeep wrangler diagnotic light is on oil
Before replacing anything get an OBII scan done (fault scan) Any good parts store IE: Autozone, Advance, etc can do it for you FREE get list of faults/messages and go from there before throwing parts at it.
3/23/2011 5:59:45 AM •
2002 Jeep...
•
Answered
on Mar 23, 2011
Not finding what you are looking for?