20 Most Recent 2006 Chrysler Town & Country - Page 4 Questions & Answers

You will have to give me a bit more information. What are you trying to repair ? You must be careful not to blow the airbag which is also in the wheel so please get back to us with exactly what you want to accomplish.

You more likely have a bulb that is no good. The next time your signals aren't working, pull over and check to see which bulb isn't working. Make sure the turn signal is on while checking. It should only be the left or right. Not both. Sometimes you can see the blown bulb with the hazards on depending on your model vehicle. Simply check the bulb thats not blinking for a tight fit. Then replace it if thats not the cure.

if you can get a late model blower housing from the wreckers it may be possible to adapt it in.

In the there is a label marked fuel reset

Lucas transmission additive helps free up sticky valves and renews seals Costs about 10 bucks. worth trying.

Open the hood, have some listen while the button is pushed. You don't hear the pump run, replace it. If it does, look for leaks from the reservoir to the back of the van. No leaks, a clogged line can sometimes be blown clear with air. Take the back nozzle off first.

Not a job for a do-it-yourselfer. Head to a QUALIFIED Auto Shop. It may have a leak that needs repairing before you have it recharged....
Good Luck,

THIN WIRE TO CLEAR /BLAST OF AIR FROM COMPRESSOR BETTER, DONT WANT TO PUNCTURE DRAIN LINE

SHOULD HAVE A KILL SWITCH, MAYBE THE REMOTE ON KEYFOB IS ACCIDENTELY BEING HIT

HIT IT CABLE STUCK

Have you checked to see if the fuel pump is getting power from the relay and if the pump is producing fuel pressure ?

My bet is a leak shorting out your fuse panel since it is affecting so many systems that are unrelated except at the fuse panel. Check all fuses for burnt/blown fuses. Check for water intrusion near the fuse panel after a rain event. If this does not steer you in the right direction, you will have to get a technician to do an electrical diagnostic to find the short.

you need to check for an exposed wire , sometimes people put in an amp for there sterio and run the wire wrong may be grounding out...wrap or remove and replace wire

Battery low? If so, bad alternator?

Hey LM these are the steps to remove alt

The antilock brake system has a problem and needs servicing quickly before you have an accident.

Need a shop to check for generic & enhanced data obd codes & find a problem How would a fuse be a problem? A fuse is either good or blown If it is blown, you have to find out why Gas Cap issues are part of the Evap System Again-- enhanced code checking, in that module Today's vehicles are beyond the owners ability to work on, without the knowledge & professional tools