20 Most Recent 2006 Chrysler Town & Country - Page 3 Questions & Answers

0helpful
1answer

Where is fan relay located?

In fuse box engine compartment and yes it is easy to replace
10/21/2015 2:31:45 AM • 2006 Chrysler... • Answered on Oct 21, 2015
0helpful
1answer

Need to get stuck DVD out. How do I remove the DVD player?

Before removing the DVD player...1st try inserting an old DVD disc under the stuck one, and press eject...this usually works...hope this helps.
9/25/2015 4:32:49 PM • 2006 Chrysler... • Answered on Sep 25, 2015
0helpful
1answer

Wiring order diagram from coil to spark plugs on a 2006 chrysler town and country

if you haven`t removed all the wires at the same time replace them one at a time. look on the coil tower were the plug wire attaches to it some show the cylinder #. cylinder #1 is rear of motor by firewall and cylinder #2 is front of motor by radiator both on the passenger side. even numbers along front of motor uneven numbers along firewall. cylinder #5 and #6 are on the drivers side of motor.
9/9/2015 4:28:25 PM • 2006 Chrysler... • Answered on Sep 09, 2015
0helpful
1answer

Where is the orifice tube on the ac system located

it is on the TX valve of the ac system and is situated at the inlet of the evaporator under the dash
8/9/2015 8:54:24 AM • 2006 Chrysler... • Answered on Aug 09, 2015
0helpful
1answer

Rear end shakes when I hit 65 mph. Runs smooth until I hit that speed. Ideas?

tires out of balance--bad tire thread damage --hub -going bad -strut /shock going bad
7/27/2015 1:56:21 PM • 2006 Chrysler... • Answered on Jul 27, 2015
0helpful
1answer

Where is ambiant air temp on 2006 town and country3.3

TEMP SENSOR IS LOCATED BEHIND FRONT BUMPER COVER CLOSE TO AC CONDENSOR. CABIN FILTER SHOULD BE UNDER COWL PANEL ON PASSENGER SIDE
6/22/2015 5:28:21 PM • 2006 Chrysler... • Answered on Jun 22, 2015
0helpful
2answers

When ever i would turn right it would die on me. I changed the crankshaft positioning sensor still does it. can anybody help?

Check the power steering pressure switch. It should idle up the engine when you turn the wheels and if not working correctly can cause one to die.
6/22/2015 5:17:58 PM • 2006 Chrysler... • Answered on Jun 22, 2015
0helpful
1answer

When starting horn honks once why?

I would think it has some thing to do with your anti theft alarm , do your lights flash once also , is it a factory system or aftermarket.
6/17/2015 8:19:30 PM • 2006 Chrysler... • Answered on Jun 17, 2015
0helpful
2answers

I changed a module on the ignition now it dont want to start

The module must be programmed (flashed) with the vehicles computer module. It requires a software program and special equipment only avail at dealerships and special mechanics that deal in automobile ignition systems.
6/8/2015 1:51:49 PM • 2006 Chrysler... • Answered on Jun 08, 2015
0helpful
1answer

1 believe the security in my van lock itself after i put a new ignition module

You will most likely need a scan tool to see which module or system is not functioning.
6/7/2015 3:44:20 AM • 2006 Chrysler... • Answered on Jun 07, 2015
0helpful
1answer

I have a 2006 t&c did not come with remote or headset the DVDs player came on once but will not come back on. Have hit the cd/ aux button getting nothing

If it didnt come with those items im guessing it was bought used and not new. If so then more than likeley it was damaged and the most common damage is that they blew out a fuse or relay and didnt know how to fix it so just left it that way.

Again, under the asumption you got it used this way, I would check those things. I would also see about doing a hard reset by disconnecting the battery for about ten minutes, let the power drain out. This will reset everything in the head unit. Some head units have a reset button like a tiny hole for a paper clip to be inserted and held down while the vehicle is on and it resets it. Usually you find it next to the cd/dvd slot.

If you were lucky enough to keep or have the manual on hand it will have some trouble shooting steps as well or may tell you where it is.

Finely, if the basic troubleshooting doesnt work and you dont want to take it into a dealer due to the cost involved, you can order on amazon or find a Chilton repair manual for your vehicle at a local Autozone, Oreilly or Advance Auto. Call them ahead of time and they can look it up and even order you one.

Have your Year, make, model and VIN I.D.

With these things it can be a quick fix or a really expensive headache. If you arent mechanically or electronically inclined it can be the latter.

The manual will show you more or less how to remove or install it more or less. Thiss is good to know because it will help you trace back problems. However if the unit just went bad then it will have to be replaced.

Im sort of shotguning the issue here because i just dont know enough about your particular issue.

5/31/2015 9:43:53 PM • 2006 Chrysler... • Answered on May 31, 2015
0helpful
1answer
0helpful
1answer

What is the operating pressure of freon in a 2006 town and country?

Typical R134 pressures are 25-35 p.s.i. low side and 200-300 p.s.i. high side, all measurements taken with ambient temperature above 85 degrees farenheit. At idle, with fan high and system in recirculate mode, you should be able to attain an output temperature at the vents of 40 degrees below ambient.
5/11/2015 2:36:12 AM • 2006 Chrysler... • Answered on May 11, 2015
0helpful
2answers

Why did both power seats stop working in my 2006 Chrysler van?

did you check for rat bites on the wiring or on bonnet open position? even there is a chance for switch problem or low battery.
4/29/2015 5:02:41 PM • 2006 Chrysler... • Answered on Apr 29, 2015
0helpful
1answer

The van has a clicking sound and erratic gauges when the key is turned to start the vehicle.

Bad connections at battery, bad starter solenoid.
4/25/2015 9:49:36 PM • 2006 Chrysler... • Answered on Apr 25, 2015
0helpful
1answer

2006 TOWN AND COUNTRY DRIVERS SIDE SLIDING DOOR STICKS

There is a tsb out for problem with power sliding doors check with you dealer.Tsb technical service bulliten a message for dealers. Tsb #2302007 POWER SLIDING DOOR adjustment
4/11/2015 4:24:32 PM • 2006 Chrysler... • Answered on Apr 11, 2015
0helpful
1answer

I have a 2006 Town and Country. Engine light is on with codes PO580, PO 456

P0580 cruise control muli-function, P0456 evap system leak small
4/7/2015 10:14:47 PM • 2006 Chrysler... • Answered on Apr 07, 2015
0helpful
2answers

I'm at a loss. No air in my town and country. Replaced the controller and the blower. I have 12v all the way to the blower so the resister is working. All fuses and relays work.... What am I missing??

12volt the other wire you got ground most likely you dont and thats why its not working if you got ground and 12v blower motor no good
4/6/2015 1:22:18 AM • 2006 Chrysler... • Answered on Apr 06, 2015
0helpful
1answer

Type of gas for a town country 2006

Use regular gas
4/5/2015 1:24:15 AM • 2006 Chrysler... • Answered on Apr 05, 2015
Not finding what you are looking for?
2006 Chrysler Town & Country Logo

1,137 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Town & Country Chrysler

  • Town & Country Chrysler

Most Popular Question

2006 town country need remove whole

  • Cars & Trucks
Loading...