Need to add transmission fluid in Cadillac CTS 2004. How do you do it?
Posted by charlie... on
tod34 is correct. The "fill" area of this transmission is located on the transmission itself. It is a fluid leveling plug located low on the main case toward the back of the trans. You must pump the fluid in through that hole. If you are on level ground and the transmission is properly warmed, you should fill the transmission until the fluid level is flush with the bottom of the hole (starts spilling out)
Posted on Sep 08, 2010
My cadillac is stuck in anti theft mode, there is no power going to the car. how can it be reset?
Posted by supply933 on
Unhook the battery and pulle the ecm fuse to reset the ecm.
Posted on Aug 24, 2008
How do I replace the fuel injectors on a cts 3.6 cadillac? dose the upper manifold have to be removed, how do I bleed the presure off the fuel rail? Thanks for your help.
Posted by Tom Tom on
First off..Do you have the High Pressure direct injection 3.6 LLT engine or basic 3.6 Engine ? Yes the upper Plenium has to come off, but you will have to probably pull your wipers off, and the 7mm screws that hold the cowl beauty panel on and then there is enough cleareance to remove the plenium, disconnect throttle body snorkel tube at throttle body, remove 10mm bolt at brkt drivers side of throttlebody (ball stud) if I remember right, then there are 13mm bolts at back besides the obvious ones you can see and carefully lift it up off engine, thenyou can get to rails for the injectors, to bleed off 3.6 low pressure fuel system pull fuel pump fuse in trunk fuse box and start it let it run out of gas, then bleed Schrader valve too on rail, if you have a high pressure direct injection llt engine let me know, will describe procedure to you
Posted on Apr 09, 2013
what is the firring order for 2006 Cadillac cts spark plugs
Posted by j47willys on
Firing order 1-2-3-4-5-6 ------- front | 1 3 5 | of | | vehicle | 2 4 6 | ------- distributorless ignition NOTE THIS IS FOR THE 3.6L
Posted on May 22, 2010
I have a '06 CTS with the 2.8 V6. I currently have 69,000 miles on the car. The check engine light came on while I was waiting in traffic with no noticable engine problem. I called on-star for a diganosis of the problem. They informed me that I had a evap. problem. Keep in mind that the ONLY time that I have a problem is after I fuel the car. If I remove the cap without fueling, I have no problem starting the car. I am not topping off the tank when fueling either. I have replaced the gas cap with no success. This one has me confussed!
Posted by f_schreier on
same problem 06 CTS...you probably hear a ticking noise under the hood, and car will not start after re-fueling- check engine code is like a p0442? which is a leak in the fuel system. you can try buying a new gas cap from cadillac or an ac-delco distributor to start. its only about twenty dollars. disconnect battery for about ten minutes to reset check engine light or find a local shop with an obd-2 scanner to reset light and re-diagnose. If check engine light comes back on with same code replace the evap. purge valve.(about $25) it is located on the passenger side of car on the intake manifold. it has one electrical connector and two hoses connected to it. no tools required to change which is a plus! disconnect battery or find local shop to reset light again. this should take care of the problem!!
Posted on Oct 11, 2009
hi my 2006 cadillac cts has error codes po 300 303 305 343 347 368 392 and 496 can u tell me what they are or a website to find out thank u
Posted by mastro03 on
P0300 is multiple engine misfire detected
P0303 is misfire in cylinder 3
P0305 is misfire in cylinder 5
P0343 is camshaft position sensor A (bank 1)
P0347 is camshaft position sensor A (bank 2)
P0368 is camshaft position sensor B (bank 1)
P0392 is camshaft position sensor B (bank2)
P0496 is EVAP Canister Purge System High Purge Flow
Posted on Jan 28, 2011
How to reset computer so car will start after replacing battery
Posted by K K on
use a scan tool to reset the ECM
Posted on Jun 17, 2015
A tire symbol with a TC with / through it. My tires appear to be fine. This symbol is not in my manual. Any idea what it means?
Posted by ejo116 on
its traction controle this happends when a tire loses contact with the road surface
Posted on Mar 17, 2011
I am not getting gas to the injectors.
Posted by Orion... on
You must remove the fuel tank from the vehicle to get to the fuel tank module. Your vehicle is equipped with two fuel tank modules that are connected by a tube inside the fuel tank. The primary module is the one on the left side and it is the one that contains the fuel pump.
Have you scanned your computer system to verify that there is not a problem with the security system or the fuel pump circuits? Did you actually check for fuel pressure at the fuel rail? I'm only asking because dropping a fuel tank and replacing a fuel tank module is not easy or cheap....A BIG investment if you are not absolutely certain that this will fix your problem.
Posted on Nov 14, 2011
I have a 2006 cadillac cts, it did not come with a navigation system, is there anyway i can install an in-dash system without messing up the the control buttons on my steering wheel?
Posted by quintana... on
There is a company called PAC that specializes in modules like you describe - keeping the steering wheel controls functional with an aftermarket radio.
Click HERE to visit their site. You have to choose a compatible manufacturer. Basically - it is turning the steering wheel controls into a "remote" hidden in the dash.
CLICK HERE for the PAC installation guide for the 2006 CTS
For best results and compatibility, look for a shop in your area that carries PAC - it is a common manufacturer in the BIZ, and have them install it.
The simple answer to your question is YES as long as you use the module compatible for the brand of radio you are installing.
Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.
Posted on Mar 05, 2009
722 questions posted
Usually answered in minutes!