20 Most Recent 2006 Audi A4 Questions & Answers

I really think you should go to www.reliable-store.com they have got books on every vehicle and also how to service/repair it, parts info, wiring diag, electrical diag, fuse diag, error codes, etc everything

It will depend on the part you need. New parts are always recommended. You could possibly use mechanical parts from VWs, SKODAs and SEATs as they all use the same parent company.

You just go to the link below, I'm sure you will get the solution of your problem https://www.reliable-store.com

Trace which way the water went down ,,, a major plug around one of the front foot wells could be full of water ... also now you need to check all the fuses. Push on the carpets front and rear floor to see if it's not flooded out under the carpets. Some cars have computer modules under the front seats.

Greetings, I read your question and I think Reliable-Store can help you in this. Here's the site link. 2006 Audi A4

That is very likely a wheel bearing staring to go out to lunch.

Could be a transmission issue. Did you hit any objects while driving ? Have you performed a visual inspection under your vehicle ? Have you checked to see if you have any loose vacuum hoses ? Any codes in your engine control module or transmission control module ?

U paid 290 euros and they did not fix it. I would go back and insist that either they fix it or return my Euros so I could take it to a competent mechanic.

Most of the time when an epc light comes on and you have no throttle response it's best to connect it to a bag-com but if you don't have one have the computer scanned for a check engine code remember just because there's no check engine light on doesn't mean the ecu doesn't have on in memory.. So if you do have a code like p1639 then you have a bad accelerator peddle

Try cleaning your maf sensor it may help

does it start at all? Or is it just completely dead and just cranks and cranks?

The first thing that you must do here is to have the systems computer checked for fault codes, it should have a few in memory. the codes are read through the diagnostic port under the dash.