20 Most Recent
2005 Isuzu Ascender - Page 2 Questions & Answers
Misfires
a misfire has nothing to do with crank and cam position sensors . those are for timing. check the ignition control module or coils and the spark plugs
11/24/2014 11:33:06 PM •
2005 Isuzu...
•
Answered
on Nov 24, 2014
Blower location motor
you only replace it if the hot wire test fails
and the fuse is good.
do you have 12vdc to the fan connector ON>
that be first.
most cars replacing it can be "lost weekend" so do that test
and save the weekend.
ask.
Install coil pack.
is the missing words,
How to? like in how to remove the bolts and put it back?
is this a single coil
or COPs.
(varies by country)
how to unbolt a COIL pack?
well you unscrew the bolts. is that what you need?
its just a coil?, unplug it and DO NOT MIX wires if this is a wasted spark coil pack, do not.
if cops, say so, 6 cops.
I dont think 2005 has a distributor. so you have either 6 coils
or 3 coils in a pack.
some call the wasted spark pack a coil rail, but is just 3 coils
packed in plastic,
say what you need, get help.l
Install coil pack 2005 isuzu
Great! Take the black plastic resonator off the top of the engine along with the hose attached to it, it's 2 bolts on the left hand side. After removed, you see all 6 coils (pear shaped) starting with #1 cylinder nearest to radiator in order to #6 at the firewall. Remove the 1 bolt holding the coil and electrical connector, and pull straight up and out. Best to buy new coil gaskets if yours are hard, water can actually get in there because of the defective hood seal. Because of this known problem, check each cylinder for water, especially #4 and #5 and remove water if present, clean coil boots and the springs inside with WD40. While you're doing that, best to replace the plugs too. These engines love AC Delco 41-103 plugs for smooth idle. I use an extention and a knuckle to get to #6 by the firewall. If you have any questions, ask away!
2005 isuzu leaking water at exhaust connection
This can be a result of blown head gasket. Your vehicle is suppose to have water build up in the exhaust but this is limited to a small quantity. if it pours out, you have a water port which leaks to the exhaust. replace as soon as possible to avoid further engine damage. the flange gasket is also not good anymore this is why you can see the water coming out there.
How to fix dented rear bumper
Take the bumper off you'll need a heat gun to heat it up but not hot enough to melt the paint. And it should come out by pushing easy.
Not finding what you are looking for?