20 Most Recent
2003 Dodge Stratus Questions & Answers
Where to put manual transaxle fluid on a 2003 dodge stratus coupe 2.4L SOHC
There is a small pipe threaded plug on the drivers side of the tranny about half way up the body and around the rear center from front to rear. When removed,fluid should flow from the hole(providing the vehicle is level on all axises), if not, fill to top of the hole with new gearoil or tranny fluid whichever is specified in your manual.
Remove heater core 2003 dodge stratus
This is a BIG job, requiring removal of the dashboard, discharging the a/c system, and removing the heater/airconditioning unit from the car (a big box with the evaporator, heater core, blower fan, and various doors that direct airflow). If you want to DIY, there are several videos on YouTube for similar models - you can view those to get an idea of what is involved.
11/10/2019 12:27:49 AM •
2003 Dodge...
•
Answered
on Nov 10, 2019
2003 dodge startus r/t computer said the warm up catalyst was bad
I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master.
It would'nt move forward or reverse, engine was good both solenoids for forward and reverse worked, but still couldn't diagnose the problem.
I don't have much technical knowledge but I just followed it step-wise, and now it works perfect! covers wiring, codes, diagrams, torque specs, PCV, everything
got it from
www.reliable-store.com
What parts do I need for purge flow fault on dodge stratus 2003
If this question is with regards to a fault code of P0441, the following applies.Basically this means that there is a problem in the EVAP system. The computer will command the purge control valve open and if it does not sense the right amount of vacuum then it will set this code.The purge valve is part of the EVAP system. The purpose of this system is to take all of the excess fuel vapor from the gas tank and store it until it can be burned in the engine. If it weren't for this system then all of those vapors would be vented into the atmosphere. Usual causes for this code:Faulty Purge Control SolenoidFaulty Purge Control ValveDamaged Wiring to the Purge SolenoidOther possible causes:Faulty ComputerRestriction in the EVAP SystemFaulty Vacuum Switch
Not finding what you are looking for?