20 Most Recent 2002 Pontiac Montana - Page 5 Questions & Answers

You may need to consult the original service manual, available here. I found a 2nd hand manual in good to excellent condition here for $139. Not cheap I know, but it will get your lights going http://www.faxonautoliterature.com/2002-VentureMontanaSilhouette-Repair-Shop-Manual-Original-2-Volume-Set-P14094.aspx

Reseting the power sliding door gm Montana or venture? In: Chevy Venture, Pontiac Montana [Edit categories] [iframe style="BORDER-BOTTOM: 0px; BORDER-LEFT: 0px; VERTICAL-ALIGN: bottom; BORDER-TOP: 0px; BORDER-RIGHT: 0px" id=google_ads_iframe_/51859126/answ_desktop_question_answered_600x300_alt_0 height=300 marginHeight=0 src="javascript:"[/iframe] Answer: It's in the owners manual under power door. I believe you pull the fuse under the hood for 15 sec with the overide switch in the off position. ...(roesterman adds...).My power door was opening all the way then closing immediately. I used this method to reset door and it worked! This started happening after I had some body work done to vehicle..maybe they disconnected battery or something. Delay locking was locking doors before slider was closing too. This left the door unlocked. I haven't tested to see if this has been corrected by reset yet.

Give me a call. Dave 8016635540

The fuel pump may not have been the problem? You are not getting a spark (ignition) and/or firing due to timing, retardation, plug gaps need setting and cleaning, plug wires may be bad as insulation may crack, peel, split, or water and oil got on the contacts. The there is FLOODING is too much fuel prevents Air from entering the chambers. So many reasons, it needs a technician with test equipment to search for the sources.

no I don't think so , it is only the torque converter clutch engaging and disengaging due to engine load. if you want to test this. go on steady speed over 50 mph no gas pedal movement. touch lightly the brake pedal but not braking and release . during this see the rpm drop down and raise hope it helps

It could be a main computer or it could be some of the big fuses inside fuse panel

go to autozone dot com, make a free account then put in the year make and model and look at the free repair guides for electrical.

Yes the flashing light means the module did not read the chip in your key as being the right one for the van.Could be the key, the sensor in the lock cylinder, or the module.

run a feed direct for the permanent 12v supply and a wire from the ignition switch for the 12v switchable supply .

Something in your ignition system or circuit must have quit. The code does not seem to be related. Have you checked for spark? There is a good read here on the code-a complete run through of what to check. .there is a good read here on TTT

Try to get an oil change or seal under the car to keep the trans fluid leaking.

I had that problem, the fans weren't coming on and plus I had low coolant