20 Most Recent 2001 Ford Taurus - Page 8 Questions & Answers


Here's a link to your P2197 code. http://www.obd-codes.com/p2197

2001 Ford Taurus | Answered on Jun 17, 2015


you can try and google image it

2001 Ford Taurus | Answered on Jun 17, 2015


add coolant or check coolant temp sensor by the thermostat

2001 Ford Taurus | Answered on Jun 17, 2015


no,only from 2000 back and then everything changed,but,if it looks the same then keep it,your best bet is to search for the parts that you want to save,if they say 99 to 2001,then it will match,so,find an auto parts store online,type in the part and check it,its about all you can do,but,it will be the correct info that way.

2001 Ford Taurus | Answered on Jun 13, 2015


Code P0705 - Transmisson Range Sensor Circuit (PRNDL Input)
The transmission range switch detects the selector lever position and sends a signal to the TCM.

The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM).

Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes
- Open or short park/neutral position switch circuit
- Poor park/neutral position switch circuit connection
- Misadjusted park/neutral position switch
- Park/neutral position switch may be faulty

Keep us updated (remember to rate thsi answer).

2001 Ford Taurus | Answered on Jun 08, 2015


Maybe the nut that hold the wiper to the linkage is either loose or stripped? The linkage itself is bad?

I think your wiper motor is fine because the passenger side works and uses the same motor to move the wipers.

2001 Ford Taurus | Answered on Jun 05, 2015


There should not be a seperate fuse. Does it work from the passenger switch? You can try banging on the door while operating the switch to see if the window will move. If it does, the motor is most likely the problem

2001 Ford Taurus | Answered on May 31, 2015


It takes about 45 minutes with lift and air tools and 2 hours by hand then a recharge of system.

2001 Ford Taurus | Answered on May 22, 2015


Hi I can't give sn accurate answer with knowing what the vehicle is! A few things you can check if hydrolic stering. Is there fluid in the resivour? Is the belt turning the pump?? Are there any visible leaks??? If its electric stering are there any lights on the display, if so go to a mechanic to get it diagnosed. Regards Jim...

2001 Ford Taurus | Answered on May 20, 2015


Check power steering pump, fluid level, belt that runs power steering.

2001 Ford Taurus | Answered on May 20, 2015


in the strut tower . front or rear

2001 Ford Taurus | Answered on May 19, 2015


If equipped with a security system, the security module is not recognizing the new key and may have to be programmed by the dealer

2001 Ford Taurus | Answered on May 17, 2015


Two bolts

2001 Ford Taurus | Answered on May 15, 2015


You may be speaking of the Fuel Pump/Fuel Gauge Sensor located Under Car On Front Side Of Fuel Tank. I never heard of a Flex Fuel Sensor.

2001 Ford Taurus | Answered on May 12, 2015


Remove overflow bottle and raise tensioner remove belt and replace reassemble in reverse

2001 Ford Taurus | Answered on May 04, 2015


Does the vehicle run and do you have other keys if so try another key

2001 Ford Taurus | Answered on May 03, 2015


Fuses And Location Appear To Be Same.

2001 Ford Taurus | Answered on Apr 24, 2015


It looks like one (or more) plugs is not working. Check wires and plugs: those that don't work will be wet and cold.

2001 Ford Taurus | Answered on Apr 24, 2015


if the engine is being turn'd over by the starter then the starter is fine. you say the fuel pump was changed have you checked it is pumping. and no air in the line. as an air bubble will stop fuel getting to the engine. also the coil pack was change was it for the same year as your car as there are meany types been made for different ecu types and if it is the a matching pair it will not spark. same with sensors they need to be paired to the right engine cam/crank... all these will make the engine not run. a pone looking there are 2 types of coil packs. and 2 types off sensor packs for different engine years check with the old part hopfully you still have them to the parts you have put on and make sur they match.

2001 Ford Taurus | Answered on Apr 24, 2015

Not finding what you are looking for?
2001 Ford Taurus Logo

3,499 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Ford Taurus
1999 Ford Taurus

2,300 Questions

2000 Ford Taurus
2000 Ford Taurus

2,061 Questions

2002 Ford Taurus
2002 Ford Taurus

1,832 Questions

1998 Ford Taurus
1998 Ford Taurus

1,403 Questions

1996 Ford Taurus
1996 Ford Taurus

1,342 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Taurus Ford

  • Taurus Ford

Most Popular Question

engine ideling rough no power wants

  • Cars & Trucks
Loading...