20 Most Recent
1998 Ford Crown Victoria - Page 6 Questions & Answers
AC FUSE KEEPS BLOWING ON 1998 FORD CROWN VICTORIA
with out knowing what you have for tools unplug different parts of the system and try another fuse like the compressor clutch the pressure switches and plug them back in one at a time til the fuse blows if you have a ohm meter check to see if any part is shorted to ground
Remove drivers side inside door panel
1. Disconnect negative battery cable2. Take a flat head screw driver pop out the little eletirc panel on the door and with all the eletronic switches on them. 3. After removing the eletric switches you will notice a screw that holds the door panel, remove that screw with a phillips screw driver and unclip all the eletronic pieces..4. Check the panel for a screw near the bottom left corner of the panel there was just a screw hole on mine but there may be a screw on yours and remove it.5. Grab the bottom of the door panel and pull upward hard if the clips do not remove themselves with upward force use a flat head screw driver to pull them up don't break them. 6. Once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.7. For access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place. 8. Installation is the reverse of removalViola
Not finding what you are looking for?