20 Most Recent 1992 Ford Explorer - Page 5 Questions & Answers

The actuator motor off the transfer case may need to be replaced.

Brake switch is just above pedal where you apply brakes

It can, but the arm for window must first be separated from the motor

Sounds to be your c/v joint. AXLE SHAFT ALSO KNOWN AS A HALF SHAFT WHICH COME OFF TRANSMISSION AND ATTACH TO THE WHEELS. When worn are designed to let you know they are worn. Hope this helps

Plz check all fuses and relays. RELAYS ESPECIALLY.

Sounds to be a severe vacuum leak at upper intake manifold or engine intake manifold.

Typically, This problem comes from contaminated brake shoes/pads. I. E. (BRAKE FLUID OR DIFFERENTIAL FLUID). Pull all wheels and check to be sure there is no fluid on shoes or pads. Also, check to be sure brake lining is in correct positions.(I .E. ) NO BROKEN SPRINGS OR HARDWARE. Hope this helps.

This problem sounds intermittent. To ensure fuel pump is working, open fuel door and have an assistant turn on ignition switch to on position (NOT START POSITION) and listen for pump to make a whirling sound. Do this a few times after shutting switch off. Also, If you dont here pump whirling, you can spray starting fluid into air cleaner. If it starts , then its the pump

Try shooting some starting fluid in air cleaner housing. If car starts, then shuts off after burning off starting fluid then you more than likely need a new fuel pump. But also be sure to check fuel pump fuse and relay. Hope this helps

Unfortunately, It sounds to be an internal planetary gear problem, which will probably require rebuilding or outright replacing

Your local Ford dealership should be able to accomidate you with photo copy of schematics

Plz check all fuses and relays. Also make sure A B S light is not on.

YES, YOU ARE CORRECT.

Plz Check fuses and relays under the hood in engine compartment near brake fluid reservoir

You can go to your local Advance Auto Parts store and purchase auto manual (HAYNES # 36024) This will give you step by step directions on how to replace your heater core. Hope this helps

Easiest solution would be to go to your local Ford dealership and they can make you a copy of fuse box diagram

Dear friend, You can purchase an automotive manual at Advance Auto Parts that will give you complete wiring diagrams as well as other helpful how-to tips. (HAYNES MANUAL # 36024) Covers 1991-2001. Hope this helps.

Next time it stalls, carefully touch the ignition coil. If hot, check for damaged High tension wires and connections between ignition coil and spark plugs. Ussually bad connections have high resistance which make ignition coil hot forcing it to fail.

Plz Check MASS AIR FLOW SENSOR OR THROTTLE POSITION SENSOR AS WELL AS OPERATION OF P V C VALVE

Plz Check Throttle Postion Sensor, MAP Sensor And Idle/Air Control Valve. Hope This Helps.