20 Most Recent 2004 Ford Taurus Questions & Answers


If equipped there are buttons on the top of the back seat

2004 Ford Taurus | Answered on Sep 17, 2019


You can not disable it so let's start now to get to the problem//// A.do you have original transponder keys or aftermarket (if aftermarket check to see if it has a battery in the key by looking at the bottom of the key for tabs that will open it////next was the battery disconnected before this happened and you don't have a key fob and the alarm sounded if so you need to buy a fob and go through the programming process in the owners manual (you can download it from ford owners.com)then after programming the remote disconnect the battery cables and wait 3-5minutes then reconnect them when the alarm or horn starts shut it off using the key fob remote this will take you out of theft mode /// if you lost your keys a locksmith is needed do not mess with this system it will cost you a lot of $$$$ to fix it

2004 Ford Taurus | Answered on Aug 14, 2019


You can google your question or answer.
About 587,000 results (0.67 seconds)

https://www.youtube.com/watch?v=cBOTUXCannk
https://www.carcarekiosk.com/video

2004 Ford Taurus | Answered on May 19, 2019


lower dash drivers side generally , the lid/cover will detail what fuse does what function , also most radio's will have a fuse at the rear of the radio so if the fuse box one is ok then will have to get radio out and check fuse(s) at rear

2004 Ford Taurus | Answered on May 17, 2019


35psi is the proper fuel pressure while running and 40 when key is on

2004 Ford Taurus | Answered on Sep 30, 2018


SECTION 310-01: Fuel Tank and Lines 2004 Taurus/Sable Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 05/25/2004 Fuel Filter — Early Build Vehicles adobe.gif Printable View (105 KB) Removal and Installation
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
  1. Release the fuel pressure. For additional information, refer to Section 310-00.
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01.
  1. Remove the fuel filter.
    1. Push the release buttons and disconnect the fuel tube quick release couplings from the fuel filter.
    1. Loosen the clamp.
    1. Remove the fuel filter.
    a0072877.gif
  1. ani_caut.gif CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
    To install, reverse the removal procedure.

2010&c18=modelyear&c20=n874148&c35=wsm%2cfuel%20filter%20%u2014%20early%20build%20vehicles%2cs4h%2c310-01%2cremoval%20and%20installation&s=1600x900&c=32&j=1.3&v=y&k=y&bw=1171&bh=582&ct=modem&hp=n&[aqe]

2004 Ford Taurus | Answered on Sep 30, 2018


Check the fuel pressure first to find out what the fuel pump is doing.

2004 Ford Taurus | Answered on Sep 30, 2018


It should be either on the rail, or by the rail on one of the fuel lines. Hope this helps, James Booth

2004 Ford Taurus | Answered on Sep 30, 2018


The fuel pressure regulator is on the fuel rail..But it sounds like to me like a stuck idle air control or a vacuum leak..Look carefully at all the vacuum lines and make sure they are not broke or crimped..If it stuck idling high you can tap on the valve and the idle will come down

2004 Ford Taurus | Answered on Sep 30, 2018


If Th engine doesn't crank have the battery and battery cables checked for condition and corrosion. If the engine cranks and dos not start then have the systems control computer scanned for fault codes and have the fuel pressure checked.

2004 Ford Taurus | Answered on Sep 30, 2018


2005 Ford Taurus maybe needind a recalibration of the ECM.For lack of power at highway speed,Misfire at load?low RPM also,The operation of a fuel pressure sensor is to limit voltage to the fuel pump when certain amount of fuel is not needed,and increase voltage when fuel is needed.If anything you need a recalibration of the ECM.

2004 Ford Taurus | Answered on Sep 30, 2018


fuel pump or fuel filter needs replaced. sounds like fuel filter needs replaced first. then I would have a pressure check run on fuel pump to see if its working as advertised.

2004 Ford Taurus | Answered on Sep 30, 2018


About 30 to 36 PSI.

2004 Ford Taurus | Answered on Sep 30, 2018


fuel pressure at the fuel rail test port should be at least 44 PSI, when u gun the engine it shuld go up very quickly, it should never drop, if it does the fuel filter is either plugged or the pump is defectuive

2004 Ford Taurus | Answered on Sep 30, 2018


should be approx 55psi

2004 Ford Taurus | Answered on Sep 30, 2018

Not finding what you are looking for?
2004 Ford Taurus Logo

1,707 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Ford Taurus
1999 Ford Taurus

2,314 Questions

2001 Ford Taurus
2001 Ford Taurus

2,217 Questions

2000 Ford Taurus
2000 Ford Taurus

2,061 Questions

2002 Ford Taurus
2002 Ford Taurus

1,832 Questions

1998 Ford Taurus
1998 Ford Taurus

1,403 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Taurus Ford

  • Taurus Ford

Most Popular Question

bypass anti theft in 2004 ford taurus

  • Cars & Trucks
Loading...