20 Most Recent
1990 Ford Econoline Questions & Answers
Heat wont blow out front vents on my econo line
Hello,
I at one time had an econoline and the fan not blowing was the blower motor on the passenger side firewall in the engine compartment (a couple of bolts and a plug). May be a secondary fan for the rear of the vehicle this is why the rear is getting air flow.
Brakes--there is a sensor on the master cylinder or on the distribution block. If you unplug that sensor the light should go out--if it does you have a bad sensor.
Hope this helps--
6/7/2017 12:04:07 AM •
1990 Ford...
•
Answered
on Jun 07, 2017
Where thermostat
Follow the upper radiator hose to where it connects to the engine. The housing that it is connected to is usually the thermostat housing.
2/19/2015 3:03:07 AM •
1990 Ford...
•
Answered
on Feb 19, 2015
How do i replace front end spindle on 1990 ford van
there is something wrong with what you describe The spindle /stub axle doesn't turn as it is stationary and the pad would only sit on the spindle
However the pad would sit on the hub or drive axle the rotor has bearings in the centre that sits on the spindle /stub axle and if the bearings were correctly adjusted there would be no damage to the axle.
However if the axle is damaged it may be bolted to the suspension arm or if it is a strut suspension the whole strut will have to be replaced. Get yourself a workshop manual as you have already spent too much money by not having one.
1/16/2015 1:09:15 AM •
1990 Ford...
•
Answered
on Jan 16, 2015
Location of fuelpump relay
I have an 86 e350 motor home, and it has two relays. One in the engine compartment on the right side of motor. It is green and black. The other one is in the dashboard mounted on left side of radio bracket. It is gray and black.
5/28/2014 11:56:57 PM •
1990 Ford...
•
Answered
on May 28, 2014
Shift linkage for a ford econoline F150 van
If your problem is similar to the one I had, you need to look under the dash, above the steering column, there are 2 T45 torx head screws up there which can loosen. I was able to get a mechanic to do the tightening, took him 2-3 minutes, he knew right where to go. I have not had to re-tighten them, since then I have replaced the shift cable so I got a good look at those screws, it is not that difficult if you can get your head in there, you might need a flashlight.
4/19/2014 10:24:26 PM •
1990 Ford...
•
Answered
on Apr 19, 2014
Not finding what you are looking for?