20 Most Recent 1999 Ford Ranger SuperCab - Page 5 Questions & Answers

Need engine size to answer that.

There is a short in the circuit. Check for a frayed wire for the circuit.

diagram shows exhaust and intake coils

On the internet---- Google---- the question There are pictures

what is the job? is somehting busted.? are you just doing routine service? what is the question exactly.? which engine. 2.5, 3.0 or 4.0L??????????????????? are you working BOOK free>? no FSM or alldata.com account? the steps are all there, but do tell what your attempting?

need a little more information than that

gr=et manual atautoparts store

Align the timing marks:

• Align the crankshaft sprocket mark to the front cover notch.
• Align the oil pump sprocket diamond to the engine front cover diamond.
• Align the camshaft sprocket triangle to the engine front cover triangle.
  

Here are the Timing Procedures from the service manual:
Click Here I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

low oil pressure, so check oil level if ok check the oil pressure as a starting point, also have the OBD codes read as should could give a fault code to help track down the fault

you need to pull the timing back apart pull the number one spark plug and role the motor over by hand to top dead center on the compression stroke the the mark for the crank should be lined up or almost lined up line it up perfect on its mark then set the cam to its mark install belt role over by hand 2to4 full rotation marks should line up perfect . install crank pulley fire it up for a split second shut it off and put it all back together

Overdrive flashing probably means that overdrive has been disabled due to a detected problem such as overheating. i would get it checked out.

Might want to check to see if you have a bent rim or a bad tire.

it maybe a metal sensor, which has been replaced with a plastic sensor. not hard to change, however make sure the two hoses are in good shape, no cracks etc. may mount with two 7 mm screws. be careful...jim