20 Most Recent 1994 Ford Taurus - Page 5 Questions & Answers

What engine? 3.0 DOHC 3.0 OHV 3.8 liter I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

no not the axle shafts.
if you want to remove the transmission you will but not the axle shafts.

hope this helps
thank you
jm

Cylinder/piston 1 is on the firewall side of the engine, and the firing order is 1, 4, 2, 5, 3, 6:

In order to replace the heater core the entire dash will need to be removed from the vehicle. The heater core access door can then be removed and the heater core replaced. This is a huge job! I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Please look at the underhood emission system hose routing guide.

Did you replace ignition leads? What about air intake leaks. Air = fuel. No air = no fuel = no start.

check your fuse. if its fine then your light switch is blown

Faulty Injectors...

Sounds like a head gasketHard to tell what your saying to be honest

check your fuses or the switch in the trunk on the right side on the passenger side on the panel you will have to move the carpet to get to it.

Your ECC has no memory cards that have to be transfer to the other ECC, the ECC is a seal unit, just install, no reprogramming needs to be done, ECC is under hood, passenger side, rear engine area, above passenger side blower motor, mounted on fire wall.

you changed rotor cap make sure plugs are in the right fireing order or timeing is off from changing belt

Go to You Tube Video, to see & learn the answer

Change the gears