20 Most Recent 2003 Dodge Ram Maxi - Page 9 Questions & Answers

3rd gear malfunction. Common fix, replace 3rd gear solenoid. If you need further help, reach me via phone at https://www.6ya.com/expert/dennis_f849d3d6a68c6430

indicates a broken /bare wire at the tilt mechanism area

I would say it's a pretty sure bet that you somehow got the valve timing wrong when you installed the new chain. I assume that you had a good service manual to take you through the exact installation procedure - if not, you should. Its just one of those things that is very easy for a first timer to screw up and its one of those procedures that you always want to double and triple check before you put everything back together. Of course if you have a distributorless ignition system, like most modern cars and trucks, then I suppose you also could have damaged a crank angle sensor or just forgotten to plug it back in. If thats the case then the ECU will through out a code though and that is easy enough to check. I assume you have a code reader of some kind.

Catalytic 1/1 Efficiency http://www.autocodes.com/p0422_dodge.html

code p0335 refers to crankshaft position (CKP) sensor --circuit malfunction====causes ---wiring---ckp sensor ---ecm you have checked the wires from ecm connection to sensor connection and eliminated the wires and connections so that only leaves a problem ECM try substituting the ECM with a known good unit and see it the code is eliminated

Try You Tube !

The fuse maybe blown under the hood ! Check it out on You tube !

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

No use the recommended gap.

What kind of alarm? Security? Possibly could have blown the TIPM. Check fuses first. Then check codes.

A well equipped locksmith may be able to do it, call first, or the dealer of course can for sure about $160.00, it can't be done at home without the correct scanner ($2500.00) to interface with the system.

codes refer to transmission control module problems === causes wiring --poor connections ---short to ground -- wiring short to positive - TCM check the condition of the wires at the box and the connections for loose, water and corrosion , then replace the TCM unit

No,the cat is not the problem,removed mine,got more power and better gas mileage,what size engine do you have,when was the last time you changed the fuel filter.

Replace both 02 sensors on that bank 2

Scan for faults probably a back up sensor not working, the scan will point to which one(s) check for corroded wire harness left rear side of box near the bumper. Heated seats if the control button lights up while running then go off probably a grid burnt out in the seat cushion or the seat back if no lights then it points to control or wiring,may set a fault for this also.