20 Most Recent 1999 Dodge Ram - Page 3 Questions & Answers

Sounds like tires need to be balanced.

You need to have the tranny tested. Most tranny shops will do the diag for free.

a wrecking yard would be my best guess for a replacement steering column, cheapest also.

the speedo and odometer are both worked from the VSS ( (vehicle speed sensor) check for the reason of metal on the sensor end could have an internal problem that is not allowing the shifting down so have the transmission check out bat an accredited transmission shop

That is the difference between reading codes & reading the computer readings. The codes don't necessarily mean the part is bad, emissions, electrical shorts, vacuum leaks make sensors set codes. YOU MUST READ THE SENSOR READINGS>

Hi. You need a new Electronic Brake Control Module (EBCM). It can be done by you but it is in a very tight place. Small torx head screws that are facing the floor boards to remove this module.



Electronic Brake Control Module (EBCM) 2. Brake Pressure Modulator Valve (BPMV) On the left side of the inner frame

That year dodge was known for bad transmission's. I dont live near you so i cant help you with a good transmission shop.if you find a good mechanic you could buy a aftermarket trans from (jasper engines/Transmission's) for example and have your mechanic install it.

If it cranks good but won't start, have a helper crank it while visually check for spark at the spark plugs. If spark everywhere, use a gage and check proper fuel pressure. Also, check fuel injector pulse. If your missing several system, an example, at the ignition coil and fuel injectors, engine cranking, check the dark green wire with orange tracer for voltage? If no voltage that leads back to asd relay. I'm not saying the relay is faulty. Your computer has to see both the cam and crank sensor signals or it may not ground the asd relay. The asd relay supplies voltage to several systems.

You should be able to access the Prodigy Instructions ie Wiring Diagram At google. Maybe an install video on You Tube. Make sure everything you do is properly fused. Any thing as far as color codes will need to be Prodigy specific. Prodigy may have a 1-800 Tech line. They should be able to E-mail you a PDF file.

There is a vacuum hose routing guide under the hood, look at that to figure where it goes.

did u look at the fuses under the hood there might be one there other than that sounds like you wiring went bad or the part of your switch is bad replace the switch

Make sure the vacuum line is connected under the hood. The line will go from intake manifold to the firewall. If you need further help, reach me via phone at https://www.6ya.com/expert/dennis_f849d3d6a68c6430

Hi, This is usually a sign of LOW Antifreeze/Coolant. Check your fluid level. - WHEN THE TRUCK IS COLD or you can get burned by hot fluid!! Make sure you add a 50/50 mix of antifreeze and distilled water. GL, TD

Run a diagnostic test to find out where the cause is. Could be sensors, Mass air flow meter, plug wire.

Make sure battery has a full charge and battery connections all good. Make sure your charging system is working properly. Note the blower diagram. The top wire is voltage, the bottom wire is ground. Use a testlite to check voltage. The resistor block and heater control are on the ground circuit, if you think a problem with ground, just use a redundant ground for testing, that other stuff doesn't matter at the moment.