20 Most Recent 1998 Dodge Ram 3500 2WD Questions & Answers


P0216 - injector timing control circuit

P0234 - turbo / supercharger over boost condition

P0523 - engine oil pressure sensor / switch circuit high inout.

1998 Dodge Ram... | Answered on Jul 26, 2018


you don't repair it on this engine u replace it. the repair requires the removal of the engine

1998 Dodge Ram... | Answered on Dec 09, 2017


Is headlamp connector a three wire connector? One should be voltage, hot all the time, use a digital multimeter to check for voltage. The others should be ground. Your dimmer and headlamp switch are on the ground circuit. One way to check ground would be to use a redundant ground jumper wire, If the lamp then works correctly, the problem is ground. Hopefully you can bypass switches to rule them in or out. If you bypass switch and lamp works correctly, then the switch is faulty. Just my opinion.

1998 Dodge Ram... | Answered on Dec 03, 2017


its on the back of the fuse box cover that snaps in the side of the dash

1998 Dodge Ram... | Answered on Nov 28, 2015


Usually a diagram under the hood

1998 Dodge Ram... | Answered on Apr 18, 2015


When the key is turned to the start position, the pump should run for about 20 seconds. Do this 3 or 4 times to prime the pump.

If it still doesn't start, the bad lift pump may have damaged the injection pump. Crack a fuel line loose (don't remove it) and turn the engine over, you should have fuel at the fitting.

1998 Dodge Ram... | Answered on Dec 22, 2014


git started?! or go to the local junk-yard and git anther 1. is the question HOW TO DO THIS? or what? lol.

1998 Dodge Ram... | Answered on Apr 13, 2014


Your brakes are telling you they require service. Please take your car in for important brake service.

Thank you for your interest in FixYa.com

1998 Dodge Ram... | Answered on Apr 02, 2014


1998 4wd club cab, same problem, found 2"x2" box the seat belts are pluged into luckgood under the middle of the front seat, gave it a good tap and I'am good to go.

1998 Dodge Ram... | Answered on Mar 27, 2014


there should be no air in the cooling system and the system can be bled by using a pressurising equipment . Ensure that the thermostat is placed in the motor the right way with the body facing the hot water (head or block). Air defeats the purpose of having a pressurised cap and system.

1998 Dodge Ram... | Answered on Jan 01, 2014

Not finding what you are looking for?
Cars & Trucks Logo

151 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ram 3500 Dodge

  • Ram 3500 Dodge

Most Popular Question

99 3500 dodge ram problem low beams

  • Cars & Trucks
Loading...