20 Most Recent
1998 Dodge Ram 2500 2WD - Page 6 Questions & Answers
Fuel guage
did you change the the pump seal or seals as there may no pressure buld up in the tank to help the gauge work.
I need the touque specs
HUB AND BEARING ASSEMBLY NUTS TORQUE TO 125 FT LBS THE HALF SHAFT AXLE TORQUE TO 185 FT LBS.
I need a diagram or pic of all ground points a 96 dodge 2500 gas vin z engine.
If you can name a component that has a ground problem, i'll see what I can find, but, all grounds, that's throwing a wide loop. Battery connections all good? odds and end components, I just use a redundant ground. Splice into the ground wire, run wire to clean metal spot. i've done it many times, haven't had any issues, just depends, ground for what?
2012. Where is turn signal flasher?
https://ibb.co/bFQfxGg
Click on the link, check that fuse. Not only check the fuse, use a test light and see if voltage at the fuse. Some fuses are hot all the time, some go hot with key on. The turn signal fuse usually goes hot with the key on. So, check it both ways. I don't believe there is a separate flasher, the circuitry is integrated into the integrated power model, located under the hood. That fuse is located in that module. If I'm wrong, my bad, my database didn't show a separate flasher.
Not finding what you are looking for?