20 Most Recent 2004 Chevrolet Silverado 3500 - Page 4 Questions & Answers

0helpful
2answers

How common is it for the drive train seal to go

Not very common - but posible..

Hope this helps !!
7/14/2009 2:12:55 PM • 2004 Chevrolet... • Answered on Jul 14, 2009
0helpful
1answer

2004 silverado gas gage stuck on E

sending unit is stuck or there is no power to the unit
7/10/2009 11:37:03 PM • 2004 Chevrolet... • Answered on Jul 10, 2009
0helpful
1answer

2004 chev. silverado 6.0 liter. The engine code

Yes they could a PO300 is a generic misfire code. PO301 would be cylinder number 1 so on and so forth. check the resistance of your plug wires they should be approx. 7000 ohms per foot. it could also be a coil over plug. primary resistance of the cops should be 1-3 ohms. but since this is a misfire it would be your secondary. which should be between 20000-30000 ohms. hope I helped you out. Happy Motoring!
7/6/2009 1:17:11 AM • 2004 Chevrolet... • Answered on Jul 06, 2009
0helpful
1answer

I have a 2004 Silverado and I had to replace the

There is a electric actuator that controls the vents and they may have lost there base. Turn the A/C controls off and disconnect the battery again and make sure your radio is off too. Reconnect the battery after 1 min, turn the ignition key's to the run position for 30 second and then turn it off for 5 seconds and start the engine. Turn on the radio and reset the station and clock, Hope the electronic actuator reset it self, if not they over run and the gears have cracked and needs to be replaced. Good luck and hope this helps. keep me posted, be glad to help.
6/27/2009 4:42:57 AM • 2004 Chevrolet... • Answered on Jun 27, 2009
0helpful
2answers

Steering gear box knock

Lube your intermediate steering shaft. It is very easy. Remove the bolt in the shaft that you can see from under the hood and push the steering shaft up toward the firewall. Where the shaft goes into itself place some grease and work it back and forth. This will last quite a while, but is easy to do again if need be. Replace the bolt and you should be go to go. The dealer will charge you $150 to do the same job. The knock goes away as soon as you test it out.
4/21/2009 11:34:04 PM • 2004 Chevrolet... • Answered on Apr 21, 2009
0helpful
1answer

How long to replace front and rear brake pads in chevy silverado

complete brake job 2.0 hours
10/16/2014 6:21:17 PM • Chevrolet... • Answered on Oct 16, 2014
0answers
0helpful
1answer

2001 Chevy Silverado 3500 6.0L

This sounds like the hydroboost unit is leaking.behind the master cylinderThe braking system on this using the power steering pump to provide power assisted brakes instead of a brake booster. The hydroboost unit most likely needs replaced.
12/27/2012 9:05:24 PM • Chevrolet... • Answered on Dec 27, 2012
Not finding what you are looking for?
Cars & Trucks Logo

96 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Silverado 3500 Chevrolet

  • Silverado 3500 Chevrolet

Most Popular Question

dash wireing diagram speedometer dont

  • Cars & Trucks
Loading...