Top 20
2001 Chevrolet Silverado 2500HD Questions & Answers
The transmission is not shifting properly.
I think that the rod that connect to the transmission needs
some adjustment if it is stuck on 2, then you need to loosen the screw and adjust the transmission by hand set it to PARK and
then your stick shift you set it in PARK the rod should be connected to the transmission you tighten the screw and your
DONE....
2001 Silverado 2500 HD Why Rear brakes don't work after I installed new hydro-boost power booster, master cylinder, calipers, and pads. I bled master cylinder before installing, and brakes beginn
Hello Patricia,
Have you checked the master brake cylinder reservoir for brake fluid loss?
I don't suspect the master cylinder as you have replaced it... but am more suspect of a leaking brake line or fitting which should have
been discovered when you had the system bled.
The only time I ever had a rear brake problem with a 2500 series Chevrolet was due to seized rear brake caliper guide pins...as your calipers are also new that is not your problem.
If your brake pedal feels spongy and travels to the floor board you have air in the system, a brake fluid leak or a failure in the power steering system, such as a broken hose, broken power steering pump drive belt, or failed pump, would result in a loss of pressure to both the hydro-boost and steering.
Find more information here:
.
Hydro Boost Power Assist Systems Operation Diagnosis and Repair
I have a 2001 2500 chevy duramax. At 2100 plus
A little movement is normal,
a lot of movement can cause fuses to blow, or burn up things like computer, radio, and backup camera. It should 've no more than 14.5 volts. Also look tension on pulley to loose can give same results.
2001 Chevy 2500HD 8.1.
You can shut off the regulator by removing the return line and blocking the return port. If pressure returns, replace the regulator. If still no pressure, check the fuel filter. Is there pressure behind it? If you remove it, can you blow thru it from behind? If the filter is not blocked, replace the pump.
Hard cold starting
This is a fuel pump pressure issue, it is not holding pressure, you must remove the fuel tank and replace the fuel pump, also replace the fuel tank connector.
Know if coil is bad
The easiest way I found is..have someone with a conductive electrical tester or timing light.i prefer the timing light..Just clamp it over the wire coming fro the coil and plug .Then start your car or if it won't start turn the engine over a fastest speed it can..point the timing light to the under hood or where the light will show..if it blinks as the engine is turning it is working if not it is bad..good luck.
How to remove a starter?
Hi roger-dodger,here's a link to your starter,you will have to stroll down more than half way to get to the 6.6 diesel engine,
How to remove a starter 2001 duramax?
1. Disconnect both
battery negative cables.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the right front tire and wheel. Refer to Tire and
Wheel Removal and Installation in
Tires and Wheels.
4. Remove the right front fender wheelhouse inner panel (1).
5. Disconnect the turbocharger exhaust pipe.
6. Remove the battery positive cable from the starter motor.
7. Remove the
solenoid wires.
8. Remove the starter motor bolts.
9. Remove the starter motor assembly.
Reset oil change code for a 2001 chevy silverado 2500
If you have an owners manual it explains it in there.. I have a 2002 Chevy express van and you have to turn the key to the on position ( do not start). fully depress the accelerater twice then start the engine. this turns the oil light off in my van. ( this was in my owners manual)
Not finding what you are looking for?