20 Most Recent
2004 Chevrolet S-10 - Page 3 Questions & Answers
My 2000 Chevrolet S10 ZR2,
Check the spark wire for the #1 plug. I had one get burned by the header, I would check it for burns or cuts. Sorry I couldnt help more.
I am looking for the factory torque settings for
IF YOU HAVE 4WD YOU WILL HAVE TO REPLACE BEARINGS.NOT ADJUSTABLE. IF YOU HAVE A 2WD YOU WILL REMOVE COTTER PIN AND LOOSEN THE SPINDLE NUT.SPIN THE WHEEL FORWARD BY HAND THE TORQUE NUT TO 12 FT LBS TO SEAT BEARING.THEN BACK OFF NUT 1/4 TO 1/2 TURN TO UNTIL HOLE IN SPINDLE LINE UP WITH SLOT IN NUT.THEN INSTALL A NEW COTTER PIN.
How do i shim the driver side door
you can get some shims or washers, loosen the bolts on the hing pillar and put in one at a time. then tighten down and check the door gaps, if still off repete untill all the gaps are good
Keyless entry not working
Mine did the same thing, but it was the battery claw on the inside of the remote has come loose from the circuit board. I bought one from www.keylessride.com its like 45bucks after shipping. Its better then the 120 the dealer wanted. They will send you reprogramming steps too, it was super easy.
Serpentine belt diagram for 2004 chevy s10
there should be a sticker on the fan housing on the top that will show you how the belt should go. If you dont have the sticker, go to a dealer, ask for the sticker, its only 3 bucks.
I need a diagram on 2004 s10 brakes
It might be worth you while to buy a Chilton auto repair manual..
Its a great book with break diagrams and step buy step, and pretty much everything else..
Makes repair jobs so much eaisier..
Really helpful..
Hope this helps !!
Please rate me good ;o)
High pitch whine
sounds like your one of your hubs on the front axle are staying engaged when you turn off the 4wd. By reselecting the 4wd high and back to 2wd hi it is causing it to release. Get it looked at these can get expensive if damage is done.
Y my check engine stays on
Just because code is for sensor does not mean that is the problem. The sensor could be simply telling telling you that it is not getting correct reading due to catalytic converter going bad. Are you trying to self diagnose?
That is what mechanic needs to do.
Not finding what you are looking for?