Top 10 2003 Chevrolet Venture Passanger Questions & Answers

2003 Chevrolet Venture Passanger Logo

Question

  • 2,639 People Helped

Chevy Venture power windows- 2003

Help... I have a 2003 Chevy Venture Minivan, with both driver/ passenger power windows stuck down. They will not rise thru neither of the switches & I have no manual on me, so I don't know where the fusebox is (I'm actually thinking it could be the fusebox) to replace the fuses (small red "mini 10")....

Help...?

Posted by on

Answer

  • Most Helpful of 2 Answers

It is possible that it is the fuse but if so something caused the fuse to blow. It may be in the wiring which if you pull up the carpet by removing the door floor trim and lifting the carpet you will see the wiring underneath. Probably laying in water. Look for splices in the wiring which will have corroded. Repair the wiring then replace the fuse.
Another problem may be in the motors found inside the doors. The brushes may have worn out. If so you need to replace the motors. Unlikely that both motors failed at the same time though.
Usually the drivers door first since it is the most used.

Posted on Dec 21, 2008

Question

  • 3,771 People Helped

How much oil does my 2003 chevy venture need for an oil change?

My husband is changing my oil &wants to know how many qts it needs..thanks

Posted by on

Answer

  • Most Helpful of 2 Answers

The book says 4 1/2 quarts of oil...

have a great day.

Posted on Jul 21, 2009

Question

  • 2,320 People Helped

replacement procedures for front struts on chevy

replacement procedures for front struts on chevy venture lx

Posted by on

Answer

  • Most Helpful of 1 Answers

lift and safely support vehicle (jack stands),remove wheel and tire assemblies, remove strut to knuckle bolts (two bolts and nuts located directly above the brake rotor very tight),then under the hood you will locate the top strut mount nuts and remove them(you may need to remove wiper linkage to do this) when you are ready to remove the last nut have an assistant hold the strut so it doesn't fall take the strut to a machine shop to get the cartridge changed (most napa stores are also machine shops go to napa online to find the one near you)
installation is the reverse of removal some cars require alignment after strut change torque specs are as follows strut to knuckle bolts 90-120 ftlbs upper mount nuts 40-60 ftlbs wheels 100 ftlbs

Posted on Sep 23, 2009

Question

  • 2,944 People Helped

I need wiring diagram for 2003 chevy venture

I need wiring diagram for 2003 chevy venture stereo harness from the factory .which colours are for what

Posted by on

Answer

  • Most Helpful of 1 Answers

Typical GM Factory In Dash Wire Color

  • Left Front Spkr (-) Light Gray
  • Left Front Spkr (+) Tan
  • Right Front Spkr (-) Light Green
  • Right Front Spkr (+) Dark Green
  • Ground Wire Black
  • Headlight Dimmer Wire Gray
  • Power Antenna Turn On Pink (if available)
  • +12 Volt Ignition Wire Yellow
  • +12 Volt Battery Wire Orange
  • Right Rear Spkr (-) Light Blue
  • Right Rear Spkr (+) Dark Blue
  • Left Rear Spkr (-) Yellow
  • Left Rear Spkr (+) Brown
Not sure what year GM changed there color codes but her it is: Typical New Radio Equivalent Wire Color
  • Left Front Spkr (-) White w/ Black Stripe
  • Left Front Spkr (+) White
  • Right Front Spkr (-) Gray w/ Black Stripe
  • Right Front Spkr (+) Gray
  • Ground Wire Black
  • Headlight Dimmer Wire Orange (if available)
  • Power Antenna Turn On Blue
  • +12 Volt Ignition Wire Red
  • +12 Volt Battery Wire Yellow
  • Right Rear Spkr (-) Purple w/ Black Stripe
  • Right Rear Spkr (+) Purple
  • Left Rear Spkr (-) Green w/ Black Stripe
  • Left Rear Spkr (+) Green

Posted on Nov 04, 2009

Question

  • 2,752 People Helped

how do I change the battery on a 2003 venture

how do I change the battery on a 2003 venture

Posted by on

Answer

  • Most Helpful of 3 Answers

For the 03 Chevy Venture you have to do the following to replace the battery.

1. Remove the windshield whiper motor cover
2. Remove the screw retaining the underhood fuse/replay panel to the fender brace. Disconnect the cable from the negative termainal.
3. Detach the fuse/relay panel from the fender brace and move it aside. Remove the fender brace.
4 Disconnect the cable from the positive battery terminal

Posted on Jan 16, 2010

Question

  • 12,164 People Helped

What is the firing order for 3.4 V6 engine and

What is the firing order for 3.4 V6 engine and need diagram of how the wires go.

Posted by on

Answer

  • Most Helpful of 2 Answers

The firing order is 1,2,3,4,5,6.The front plugs are 2,4,6 and the rear are 1,3,5.The coils are numbered if they are the factory coils.They will be 5-2,6-3,1-4.Hope this helps.Good luck.

Posted on Mar 02, 2010

Question

  • 4,099 People Helped

chevrolet venture problem P1811 maximum adapt and

chevrolet venture problem P1811 maximum adapt and long shift

Posted by on

Answer

  • Most Helpful of 1 Answers

this code is a pressure control solenoid code, I have repaired this many times by removing the transmission sidecover and valve body, cleaning the valve body, and replacing solenoid. I like to change the filter and flush the trans when I perform this repair, of course if you can't do this you will need to take it to a professional

Posted on Jun 10, 2010

Question

  • 6,153 People Helped

can a bad downstream oxygen sensor cause a rough

can a bad downstream oxygen sensor cause a rough idle on a 2003 chevy venture

Posted by on

Answer

  • Most Helpful of 3 Answers

no, the downstream sensors do not feedback into the control of the engine--they only detect the effectiveness of the catalytic converters. If the sensor is detecting excess fuel, the problem could be with your fuel pressure regulator, and that would also explain the rough idle. Do you have a trouble code you can pass to me?

Posted on Dec 12, 2010

Question

  • 4,594 People Helped

where are the 02 sensors located on a chevy venture

i need to find the bank 1 and bank 2 sensors

Posted by on

Answer

  • Most Helpful of 1 Answers

I have written a couple articles that cover subjects including oxygen sensors, oxygen sensor codes, and oxygen sensor locations. I recommend that you read these articles before pending your money on trying to replace any oxygen sensors. Click the links below to see the articles.

What Else Could Be Wrong?

Which Oxygen Sensor Is It?

Posted on Apr 27, 2012

Question

  • 3,162 People Helped

2003 Chevy venture power locks will lock but not unlock

When I put the car in drive and go the doors lock automatically, but when I stop with the van running and try to use the power lock to unlock them they will not unlock. They won't even unlock when the van is off, I have to use the manual unlock button.

Posted by on

Answer

  • Most Helpful of 1 Answers

lock and unlock use different relays

Posted on May 10, 2012

708 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29492 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

2003 Chevrolet Venture Passanger Venture

  • 2003 Chevrolet Venture Passanger Venture

Most Popular Question

put trailer hitch venture when put

  • Cars & Trucks
Loading...