20 Most Recent
2005 Chevrolet Blazer - Page 9 Questions & Answers
I have a 2000 Chevy
You can put a scanner on the car and read the code if any is set. Then repair the code.
My car is 2004 Chevy
Turn the engine over and bring #1 piston to the top of the cylinder then remove the dist. cap and be sure the rotor is pointing to #1 plug wire in the firing order. Turn the oil pump shaft with a screwdriver so you can keep the rotor pointing to #1 in the firing order set the dist. You have to pay close attention when you set the dist to the oil pump shaft or you can get it a half tooth off and car will backfire when you start it. Good luck
1992 s10 blazer power steering noise problems
It's not unusual for these pumps to make a whining noise when under high load, such as at end of travel of the steering links. Yes, the gear box could be part of the problem, but first I would carefully check all the steering linkage tie rod ends - one or more of them could be badly worn or stating to seize due to lack of lubrication.
I have an 03 chevy
replacing the barrel or keys will jot solve the problem as you will still have to get them programmed to the immobilizer system
there is a method of bypassing the immobilizer to get it to a service center
I suspect that the problem is in the keys ( flat batteries in the key fob )or the immobilizer needs to be programmed to the keys again
possible a reset of the ECM using a scan tool may help there
Not finding what you are looking for?