20 Most Recent 2001 Pontiac Montana - Page 7 Questions & Answers

Put the car on a hoist and look for an oil leak. Here are the common places to find a leak. 1) Valve cover gasket, can leak down on the backside of the engine. You should find the back of the engine wet with oil all the way up. 2) Leaking drain plug or oil filter. 3) Leaking oil pressure switch. 4) Leaking front or rear main seal around the crankshaft. If the motor and underneath is dry and has no oil present, check the inside of the tailpipe. You may have a broken oil ring on one of the cylinders, or bad valve stem seals inside the top of the cylinder head. Be blessed.

EOBD II Error Code: P0449 Fault: Evaporative Emission (EVAP) System, Vent Valve - Circuit Malfunction Possible Cause: Wiring harness. Evaporative emission (EVAP) canister purge valve. Engine control module (ECM).

have a load test done on the battery as you may have a dead cell. check and clean battery terminals and posts to shiny clean and tighten properly

loosen both nuts at the spindle .and adjust them to parking position.

Simple really, your adjusting the belt that drives it too tight, causing premature bearing failure. Install it a little looser next time around.

Frost plug, water pump leaking?

Double check your ground for the battery. Make sure connections are clean and tight. A hot wire or cable is often a loose or poor connection.

this is one of pontiacs security features, if the keys are out of the vehicle it will do this

sound like Modulator elect fault.... worth doing this first lot cheaper than tranny rebuild

Replace the starter.

yes the muffler is located on the back of the car, have some one put the car on drive and try to look at the rear of the car listen for the sound.

Park switch is bad in the wiper motor, replacement will remedy.

They should stay slightly up from the sleep position 9:30 or 10 o'clock or so

Check the blower motor resistor located under the

Let me know if this helps. Thx

Hit the starter with a pry bar and hammer? are you out of your mind? Should they re check the duct tape and bailing wire also?

misfire is detect by crankshaft sensor the rotation uneven of crankshaft.and you should have fault codes.