20 Most Recent
1999 Chevrolet Venture - Page 7 Questions & Answers
What is the line length i need for 99 chevy venture?(brakes)
You can only get brake tubing to 60"in length, maybe a little longer,so more thanone piece will be neededWhen someone asks about brake tubing, it is obvious you never went under the vehicle or havefabricated the tubing before, if you have to ask
The abs and tcs lights came on at same time
You'll need to get the system scanned for trouble codes.Some code readers will not access the ABS or body computer.A trouble code for the ABS can also knock out the traction control.
When stoping i here a bumping noise
have your front-end checked, could be bad strut, shock-absorber, worn bushing @ control-arm, not good, unsafe, this could cause that bumping noise you hear, seek repair ASAP. avoid pot holes ! good luck
Wipers stays up when off
Solved!!
I fix it on two montana . i Sit an afternoon to realise olly drop of oil is needed!!
So look at this: Open the hoot and locate the disk on the top of the wiper motor . When it run it turn allways in the same direction. when it goes to park the motor go to revese and during these process a little arm under these disk jam the one under and reverse rotation to park the wiper arm .
So look carefully at the disk .You can see there two disk stick together. put oil to unsqeeze it . you can do it when engine is off....
Enjoy it:
Becosses
Overheating
I was told this van has plastic gaskets that go out alot easier than the standard gaskets. They will make your van overheat. almost had to do this on mine. Lucked out and it was water pump.
Noheat
Is your temp gauge fluctuating ? Had same problem thought it was thermostat , turned out was just air in system
Venture blower switch
The resistor that controls the blower motor speed ,Probaly is what is at fault, End needs to be replaced, Or the switch it self, Phone a GM dealer to find out where the resistor is located in the vehilce,Evan the parts department will be able to help you out,
How do if my fuel pump went out
Check for fuel pressure at the valve on the fuel rail (looks like an over sized tire valve). Push the center of the valve. If you have good pressure, you will get about a 3 foot spray. If not the fuel pump or relay is bad.
Not finding what you are looking for?