1992 Chevrolet Cavalier - Answered Questions & Fixed issues
1992 Chevy Cavalier won't start in cold weather. New battery, alternator at Q4.4?
It is unlikely the electronics in the car (e.g. tthe spark module) is to blame, but it is possible. A more likely problem is water in your fuel system which is freezing and blocking fuel delivery. I would try adding an antifreeze (alcohol based) type of gasoline additive to your gas tank, and during cold weather make sure your tank stays almost full.
How to apply clearcoats when painting my car
Depends on the type and color of paint and temperature factors. Urethane metallic basecoats can require an hour or longer at normal temps for clearcoating. Silvers with be lighter if you fog them on and wait 4 hours to cure first before top coating. Lacquers can be clearcoated immediately after flash-off. Same with acrylic enamels.
Important factors are temperature, how much hardener used and thinner speed. Spray a small test piece for testing during your shoot. Usually min 4 hours recommended for wetsanding of urethane basecoats before clearcoat at normal shop temp if sanding is necessary for drip or bug repair. I use a drop or 2 of dish soap in a water spray bottle to prevent ball up on the 600 grit wetordry sandpaper. Don't press too hard, let the sandpaper do the work. Wash your hands often, silicas and plastic compounds are toxic.
I think I need to replace the fuel filer located on my 1992 Chevy Cavalier
I don't know litre size of engine? I looked at info for the 2.2L.
The picture, so you will know what is looks like. It should be under the vehicle towards the rear. A threaded fitting on one end, quick connect fitting on the other end.
Make sure no fuel pressure on the system before taking any fuel lines loose. Usually after the vehicle sits overnight w/o the key being cycled not much pressure, but, you need to be aware. Use a catch pan, gas will probably run out of fuel lines. If too much gas, plug the lines till you go back with new filter. Do it in the open air.
There safety issues working under a vehicle, safety is your responsibility
Engine sensors
look for vacuum leak ,spray wd40 suspected place engine rpm will change if there is a leak
IAC valve is responsible for idle .gas cable stuck look for it
hope it help
Not finding what you are looking for?