20 Most Recent 1992 Buick Regal - Page 2 Questions & Answers

try google images

You have a bad door switch, which is sticking. Try to clean it with contact cleaner or WD-40.

Very likely your fuel filter. Sometimes trash will get in the filter. The trash (debris) will settle to the bottom when nothing is being sucked through the filter (the car is not running) so there is no obstruction in the line. When the car runs the gas gets sucked through and at some point pulls that debris into a position where it blocks the flow, thus no gas get through and the car dies. Try changing your fuel filter.

First it is a junkyard or dealer item. I know what you need but don't know the name. Vacuum junction box is what I call it. There are many shapes and sizes. I call a dealer, tell them what I am looking for. They fax a picture and I pick out there number.

No. According to this site; http://www.brandtlocksmiths.com/doc/DOcGM.htm Hope this helps.

pull out the inner pad and if there are two holes or slots in the piston the you have to screw the piston back in as it is attached to the hand brake adjustment a large flat bladed screw driver may do the job

Hi Chris....When you release the brake pedal, there is a switch underneath the brake pedal that disconnects the circuit to your brake lights causing your brake lights to switch off. Sometimes this brake light switch will go bad and need replacement. For the most part, replacing the brake light switch is very simple. Simply replace the brake light switch with a new one. If your brake light stays on after you turn your car off and you don't want to run your battery down, you may be able to get down underneath the brake pedal and manually pull up on the brake light switch to deactivate it until you can get it repaired. This method will only work if the brake light switch is just sticking.

I hope this helps FixYa!

Broken connection between handle and rod only made of plastic

This may be related to the antitheft system The system is known for turning off the starter and/or injectors when it fails. Is there a light on the dash that says SECURITY? This is a common problem worth looking into. http://www.diy-gm-security.com/

There is not a simple answer, as the emissions are controlled by a system of various parts working together. Buy a cheap shop manual for a complete description.

Could be actuator.

Check you owners manual, has a diagram inside on one of the pages. or visit library and check ALLDATA online for fee.

you need a thermostat or a large washer in it,s place or water will not stay in radiator long enough to cool down. you will need about an 3/4 in opening

If this a manual check the throw out bearing as it has probably failed and the clutch is not disengaging

If there was going to be a problem you would have it by now. Steel wool is not a good idea as there are bits left over that may get between moving parts and cause problems. Normally stick with a tooth brush and wd-40 or electrical parts cleaner.

Take it to auto zone and have it scanned for free and they will read the codes that are faulty.

look for a blown fuse since as soon as you flipped on heater it quit ,ck ecm fuse,listen for fuel pump when you first turn key should run for a few seconds

look all around the lower edge of the console. You should find typically 4 screws that mount it to the floor