1992 Ford Crown Victoria - Answered Questions & Fixed issues


Take out the inner fenders or work through them but this is hard take out the inner fender splash guards it gives you more room from underneath and remove the tires those bolts are prone to snapping from age and corrosion so liquid wrench them for a few days letting it penetrate keep spraying while driving it if you have to use the car

1992 Ford Crown... | Answered on Oct 07, 2019 | 16 views


There's this website www.reliable-store.com
They have books on ALL vehicles.
it covers wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, troubleshooting owner's/service/repair/parts/maintenance manuals etc everything totally..
I have 1987 toyota 4runner model and I
keep servicing and when needed repair it on my own. worth it !!!

1992 Ford Crown... | Answered on Mar 18, 2018 | 74 views


Look at the module switch

1992 Ford Crown... | Answered on Jan 09, 2018 | 104 views


Sounds like fuel pump wiring, but could be fuel pressure regulator is bad or vacuum hose to it is bad. Also check for ANY vacuum leaks. Replace fuel filter,too. don-ohio

1992 Ford Crown... | Answered on Mar 26, 2017 | 73 views


When was the last time the transmission oil was replaced?

1992 Ford Crown... | Answered on Oct 18, 2016 | 42 views


Disconnect the battery NEGATIVE cable for 5 minutes.

1992 Ford Crown... | Answered on Oct 17, 2016 | 58 views


You either have a leak from the pump area or one of your hoses is leaking. Start your motor and watch for where it is leaking from.

1992 Ford Crown... | Answered on Jan 02, 2016 | 357 views


Air ride suspension basically works like this. you have a small air compressor and a sensor that connects between the rear axle and the under body Frame. When this sensor detects a load movement like more or less weight it turns on the air compressor to air up or opens a exhaust valve to let air out. most common problems with this system. broken or disconnected sensor. leak in the air lines between compressor and shocks. or a bad or weak compressor.

1992 Ford Crown... | Answered on May 07, 2015 | 519 views


Your exhaust system could need to be replaced. By removing the cats you lost required back pressure that gives your car power.

1992 Ford Crown... | Answered on Apr 01, 2015 | 75 views


Check your maf/map sensor. Could also be your starter on its way out

1992 Ford Crown... | Answered on Apr 01, 2015 | 83 views


The most likely cause is a bad ignition coil, remove the coil wire from the distributor and attach an old spark plug to it, have a helper crank the engine, and see if the spark plug fires. If the plug does not fire then the coil is bad. If the plug fires, remove a plug wire from a spark plug and repeat the process. If no spark then the distributor cap may be bad? Also have you ruled out no gas???

1992 Ford Crown... | Answered on Jan 11, 2015 | 137 views


Change channels ;)
(this is an old post, so I recon it was solved by the user) :)

1992 Ford Crown... | Answered on Jan 03, 2015 | 29 views


No idea what statement is about

Try again

1992 Ford Crown... | Answered on Nov 13, 2014 | 45 views


It's coming from your circulation vent,have it set on recirculation,that way the out side vent is closed,will cause carpet to mold underneath.

1992 Ford Crown... | Answered on Oct 15, 2014 | 85 views


2 possible reasons for not restarting- antifreeze in cylinders or spark plugs distorted for overheating, may need to change to restart.

1992 Ford Crown... | Answered on Jun 22, 2014 | 297 views


Does it have power seats or manual seats?

1992 Ford Crown... | Answered on Apr 20, 2014 | 42 views


Replace the filter.

1992 Ford Crown... | Answered on Apr 14, 2014 | 79 views


On rear of throttle body. There is a 2 wire connector and a big tube that goes from it to the air cleaner, it looks like a little motor and it is held in with 2 bolts

1992 Ford Crown... | Answered on Mar 17, 2014 | 150 views


fuel filter or air filter
coil going bad
tune up plugs and wires
ignition module
plugged cat. converter
fuel pump clogged or dying
bad gas, maybe water mixed in

1992 Ford Crown... | Answered on Nov 11, 2013 | 43 views


Leak on the line
plugged filter
clogged or dying pump
defective plugs or wires
Cap and rotor
plugged exhaust

1992 Ford Crown... | Answered on Nov 11, 2013 | 44 views

Not finding what you are looking for?
Cars & Trucks Logo

371 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...