Top 20
1992 Ford Crown Victoria Questions & Answers
Transmission makes a chirping sound from 1st to 2nd
There's this website
www.reliable-store.com
They have books on ALL vehicles.
it covers wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, troubleshooting owner's/service/repair/parts/maintenance manuals etc everything totally..
I have 1987 toyota 4runner model and I
keep servicing and when needed repair it on my own. worth it !!!
"Check Engine Light"
Sounds like fuel pump wiring, but could be fuel pressure regulator is bad or vacuum hose to it is bad. Also check for ANY vacuum leaks. Replace fuel filter,too. don-ohio
My crown vic turning over but wont crank never did this before
The most likely cause is a bad ignition coil, remove the coil wire from the distributor and attach an old spark plug to it, have a helper crank the engine, and see if the spark plug fires. If the plug does not fire then the coil is bad. If the plug fires, remove a plug wire from a spark plug and repeat the process. If no spark then the distributor cap may be bad? Also have you ruled out no gas???
FRONT SEATS ROCK
Change channels ;)
(this is an old post, so I recon it was solved by the user) :)
I have 1992 ford crown victoria that doesn't shift
Fluid color don't matter. Your cable or shifting linkage may have slipped or is slipping. #1 Hold brake pedal down and move shift lever very slow around the reverse indicator. When reverse activates note were indicator is located. #2 Test the other gear indicators at the proper speeds(MPH). No problems with #2-linkage problem. Problem with both-go get a six pack. Good Luck.
Not finding what you are looking for?