20 Most Recent
2002 Mazda MPV - Page 7 Questions & Answers
Indicator lights dont work but
Are you refering to your turn signal indicator lights? Do your turn signals work on the front and rear of the vehicle? If so, the problem is NOT a fuse.
If you are not talking about your turn indicators, I would need further explaination before I could tell you where any fuses are located
Please also review this article and post a "comment" if you would like further assistance:
Where's The Fuse?
Airbag lights flasing
Here's asite that will explain everything you need to know about airbag systems, airbaglights and resetting the system. Itshows you the location of the components and the procedure for diagnosingand/or resetting airbag light. Not allvehicles need everything replaced.
You cancheck to see if your car is listed here.
http://www.airbagsolutions.com/
Airbagsolutions.comalso has the fault code charts to tell you what is wrong and how to fix it!
Some vehiclemanufacturers let you access and reset systems without a scanner (like Toyota,Lexus, Nissan, Infinity, Honda, Acura, Ford, Lincoln, Mazda & Mercury) andsome require a scan tool.
Althoughit's a pay site ($14.95/day), it's a lot cheaper than going to the dealer
Here's the page in this site that tells you which cars needa scan tool and which ones can be done without
I hope I've helped you
http://www.airbagsolutions.com/scanlist.aspx
http://www.airbagsolutions.com/light.aspx
http://www.airbagsolutions.com/vehicles_list.aspx
How do I reset or
I would reset my ECM, do this by turning key to on position with a/c on then remove positive battery cable, wait 30 sec. the turn off key and replace battery cable. Good luck with it.
2002 mazda mpv 2wks ago
It could or could not be true. The engine light can mean a number things, the best thing to do is get a scan on the vehicle . The scan will tell you exactly (in most cases) what the problem is.It could be a cylinder is misfiring or maybe an injector is partially blocked
Auto doesn`t get cold enough
The low feed is back near the firewall on the left side of the engine ( as you are facing it ). Follow the METAL a/c lines one will have an H on it for HIGH and the other should have an L on it for LOW. If not, the one closest to you is the HIGH and the one back near the firewall is the LOW. This is at least what it was on my 2002 Mazda MPV ES... The best bet is to take it somewhere due to people overcharging their A/C systems. The MPV calls for 1.87lbs. of 134a coolant. Someone had 2.43lbs. in mine. Once I bled it and recharged it it runs nice and cold!
Mazda premacy 02 model, abs and tcs lights dont go
This is usually a wheel sensor that has gone bad. These are located in the wheel bearings and this is what has to be replaced. But first check the plig and wires, they some times break ot the plug can be corroded.
Not finding what you are looking for?