1996 Mazda Protege - Answered Questions & Fixed issues
Why is the check engine light is flashing?
the check engine light is on and flashing to let you know that either the engine or transmission needs urgent attention. Check coolant level, oil levels, overheating and take it to an accredited service centre before the problems become real money
7/22/2014 6:06:25 AM •
1996 Mazda...
•
Answered
on Jul 22, 2014
•
130 views
Transmission
Most of automatic dont have plug you have to make a mess slack the pan and pry the pan off a bit
4/23/2014 12:22:01 AM •
1996 Mazda...
•
Answered
on Apr 23, 2014
•
37 views
Lights and radio work but when i turn the key nothing happens
check the wire that runs from battery to the starter. take it off of starter and clean with wire brush or sandpaper put back on. if that is not the problem my next move would be to have starter tested. u can take it to auto parts store to get it tested
4/8/2014 6:39:58 AM •
1996 Mazda...
•
Answered
on Apr 08, 2014
•
38 views
Rough Idle Po120 code
Ok, first things first, have you calibrated your TPS correctly? Being closed throttle voltage of
0 -
.459v and WOT (wide open throttle) voltage of
4.98 -
5v if so then make sure your harness and connectors to the TPS and the MAP/MAS sensors are free of corrosion and breaks, and just as important ran in the OE locations not coming into contact with any other components or wiring with in the engine compartment, and that your throttle body/plate is clean and free of gummy oil build up. Now as easy as it can be people tend to write off the part its self being the cause of there problem just because they replaced it, about 2 out of 10 parts bought from a parts store are lemons right out of the box! (AZ) so keep that in mind. Moving on if that still does not keep the cel light from returning after cleared each time with scanner (KOEO) then it may be time to look at the corresponding sensor to the TPS which is your MAP/MAS. Because the ECU reads the reference signal or voltage returning from these to sensors as a action equal reaction, It can be confused as to which sensor is the colaprete. if you have further questions or need of assistants feel free to send me a message!
[email protected]
11/10/2013 8:11:28 AM •
1996 Mazda...
•
Answered
on Nov 10, 2013
•
143 views
Heater fan only works on 1 and 2
I would tend to look at the heater control head as a relay just passes voltage from point a to point b and you akready have voltage.
3/21/2014 3:28:02 PM •
1996 Mazda...
•
Answered
on Mar 21, 2014
•
91 views
Not finding what you are looking for?