20 Most Recent
1994 Mazda Protege - Page 5 Questions & Answers
94 mazda protege
try buying new points (yes there called points) gap them then install them, they go under the distributor cap, by the condenser, also, the sparkplug wires go in a certin order so if your not sure call an michanics shop and tell them what kind of car you have and they'll tell you what order they should go in. also did you gap the spark plugs??
Blinking hold
My 2002 Mazda protege had the blinking hold light problem. I went to a mechanic and he said,it could be a problem with the solenoid in the gearbox. He diagnosed all the 6 solenoids and found out that 4 out of 6 is not working, so I bought the 4 solenoids and got it replaced. But still, the hold light keeps on blinking,then the mechanic said it could be the transmission sensor, got it replaced then thank god the blinking hold light is gone! :) So,you need to check the transmission sensor first before you check the solenoid cause in my case,the fault could be just the sensor rather than the pricey solenoids.
Changed engine temp sensor and
Hello and welcome to FixYa!
If you have overheating problem, it can lead to multipleissues. You may be running on low coolant that's why the vehicle overheats. Ifthat's the case, please add coolant and make sure that it sits on the rightlevel, too much coolant can cause overheating too for coolant will overflow.
The vehicle may have a faulty or worn out radiator blowermotor that's why it overheats. If that's the case then you will need a blowermotor replacement to resolve the issue.
If the radiator is clogged with dirt and rusts this issueoccurs too. The coolant doesn't flow normally on the cooling system if it'sclogged. If that's the case, I strongly suggest that you have the radiatorflushed to drain out dirt and rusts. If you think that the radiator served youenough then it's better to have it replaced.
Please do check the radiator hoses, If you have worn outhoses it can cause coolant leakage which can result to overheating. A tiny holeis good enough for the vehicle to overheat.
A faulty thermostat sensor can cause the issue too. If youhave worn out thermostat, the fan may not trigger that's why the fan won't workwhen under stressed conditions. A blown radiator blower fuse can cause thisissue too so I suggest that you check the radiator blower fuse and replace itwhen necessary. What causes the radiator blower fan fuse to blow? It's becauseof a failing radiator blower motor, If that's the case have the radiator blowerfan motor replaced.
If the fluid in radiator doesn't circulate then it meansthat you have a blown head gasket or a faulty water pump. I suggest that you gofor the water pump replacement first specially if you think that it's near theend of it's service life. Usually, water pops out the radiator when engine isreved (a sign of faulty water pump and possible blown head gasket).
Hope you find this information helpful enough and thank youfor using FixYa! Have a good one!
The Windshield Wipers won't work and the motor
dear,
I think there is some problem with the fuse.
as giving the direct current makes it to move.....so you are suggested to look for the current supply from the battery.
check the fuse.
check the switch
thanx
Where do you install transmission fluid on a 1994 mazda protege
For a manual transmission, you have to remove the speedometer cable from the top of the transmission, including the single bolt that holds the speedometer cable housing. From there, you use a long tube and a funnel to pour the transmission fluid into the speedometer cable hole. Yes, quite inconvenient.
I have an 1994 Mazda Protege.The brake caliper
It sounds like the brake caliper has seized. If you know what you are doing, you can attempt to salvage the caliper set by taking it off the car and pulling the piston out of the housing and cleaning it up. But your best bet would be to just replace the whole brake caliper. Its not too hard a job if you know what you are doing and have a haynes manual around. But if you are not the type to turn a wrench, you need to bring your car in to be serviced ASAP. If you don't fix this soon the brake pads will wear down to the point that the whole pad drops out of the caliper and then the piston inside the brake caliper will be making contact with the brake discs. This isn't just bad for the car, its dangerous too.
Car start's but as soon as it gets warm it shuts
check for an EGR valve with a leaky vacuum diaphragm. this valve is only assigned to work when the engine is warm. When called upon, the leaky vacuum diaphragm lets in too much air and the engine leans out and dies.
What is the purpose of the water sending unit
For 1994 Mazda Protege 1.8L MFI SOHC 4cyl the Coolant Temperature Sensor is located under hood, driver side, upper engine area, end of cylinder head, mounted in top of water outlet, work for activated the electrci cooling fan whan is necessary.
How to remove a fuel pump off a 1994 mazda protege
disconnect the battery cables and undo the belts from your tank drop it and it should be right on top a couple of wires see how they are connected connect them the same way thepump it kind of locked in to the tank you should see a ring you turn to release the pump the pull it out replace it and put it back on just like you take it off.
Is the alternator located up top or a hard to
It's accessed UNDER the vehicle, and a PITA to get to.
Requires removal of the cross-member, exhaust, and more!
For the full procedure head over to AUTOZONE.com, and register for a free account...
Then use
THIS DIRECT LINK once you sign in. It will take you right to the procedure.
Thanks!!
My 94 mazda protage has
Wires and distributor cap too-they should be changed if you are going to rule out ignition problems. You can check the wires with a digital meter, but if you know they haven't been replaced in a while, do that-distributor caps are a little trickier in that they can hairline cracks or 'carbon' tracks that can disrupt the spark.
Not finding what you are looking for?