20 Most Recent 1994 Mazda Protege - Page 4 Questions & Answers

Bottom of throttle body

This happened on the 94 323 I used to have. Remove the cover on the steering wheel(If I remember correctly, it just pulls off). There is a pad that goes between the horn contacts and the steering wheel cover that breaks down over time. You can replace it with a couple layers of thin foam with a hole cut over the contacts so it will work as intended again.Hope this helps.

If it starts and idles about 2000 to 2500 rpm and won't slow down about 90% of the time replace idle up motor(sensor)

Check all the fuses, If the battery is dying it would affect all lights not just some

Some thing too check:
Make sure coolant level is up to line and clean (not dirty, do to clogged radiator, may need to be flushed or replaced).
Make sure air flow through the out side of radiator is clear (dirt, leaves, ect..) .
Make sure fan is working properly equip t (is not running too slow). Or Manual (belt driven) fan clutch is working properly, not loose or spinning too freely?
Check for broken or cracked fan blades itself.
Check radiator cap, (no gasket tears).
Could be thermostat going bad ?
Could be coolant temperature Relay or sensor/switch (from computer) going bad?
Check radiator hose(s) (too soft, may collapse)?
In some rare cases:
Timing could be off.
Could be water pump.
Could be blown head gasket(s).
Could have cracked head(s).
ECT..............Hope this was some help???

easy put some engine oil around them and leave for a day or two ,then when you refit use some copper grease on the threads and they will never be difficult to remove again

Whats the purpose of fuel shut off 94 mazda

You can change the coolant with a full removal of the R-12 and replacement of the drier. You can get R-12 to put in the system and will be better cooling for your car. R-134a is not as effecient. Find a good local A/C shop and they should be able to help you. Remeber do not mix R-134a with R-12 it becomes corrosive and will kill your compressor straight away.Good luck.

drill it out is only way

Give some more details of the problem.

step 1 17-19 ft/lb
step 2 90 degrees
step 3 additional 90 degrees
engine uses Torque To Yield head bolts
New head bolts must be used when cylinder head is replaced or re-installed

stockam auto If you need further help, reach me via phone at https://www.6ya.com/expert/dennis_f849d3d6a68c6430