1994 Mazda 626 - Page 2 - Answered Questions & Fixed issues
Not passing DEQ
To much fuel not enough air. Find out where the restriction is at.
11/26/2012 9:03:43 PM •
1994 Mazda 626
•
Answered
on Nov 26, 2012
•
60 views
Power seat motor replace
As far as I know the seat motors are not serviced separately from the entire seat track assembly, that just unbolts from the seat bottom the seat has two bolts in front and two in rear that are covered with a trim piece. Disconnect any wiring and be sure to not break the wire connector locks, don't man handle them apart.
9/6/2012 11:29:23 PM •
1994 Mazda 626
•
Answered
on Sep 06, 2012
•
167 views
Mazda 626 (1994) Random intermittant stalling
The first thing you need done here is to have the dealer or a shop scan the ECM (computer) for fault codes, this could be just a defective electronic engine control sensor like a crankshaft sensor or a defective ICM (ignition module). So before you do anything else have the scan done with the special scan tool required.
6/20/2012 10:00:06 PM •
1994 Mazda 626
•
Answered
on Jun 20, 2012
•
307 views
MAZDA 626 ENGINE RANDOM PAUSING/STALLING
The cooling system?? That would be my last guess, right after the spare tire. Sounds like an electrical issue. Quite often remote starters, especially those not installed at the factory, can cause these problems. Is there a "check engine" code?
6/21/2012 2:19:44 AM •
1994 Mazda 626
•
Answered
on Jun 21, 2012
•
718 views
94 mazda 626 cv shaft removal
Stick a large screwdriver or prybar between the CV housing and the transmission case, and pop it out. There is a little circlip in a groove near the end of the shaft inside the transaxle. It is there to seat the shaft and prevent it from slipping out during driving.
2/24/2012 5:49:27 AM •
1994 Mazda 626
•
Answered
on Feb 24, 2012
•
421 views
Madza626es firing order
1994 Mazda 626 2.0 liter DOHC L4
1994 Mazda 626 2.5 liter DOHC V-6
Contact us if need additional details. Hope this helps, and remember to rating this free answer.
10/12/2011 4:51:00 PM •
1994 Mazda 626
•
Answered
on Oct 12, 2011
•
219 views
Where is the thermostat located on a 94 Mazda 626
follow top radiator hose to the top of engine you will find it under the thermostat housing make sure you put new one in the correct direction thermostat will usally say to radiator somewhere on the lip
1/11/2014 6:40:59 AM •
1994 Mazda 626
•
Answered
on Jan 11, 2014
•
296 views
I have a 1994 mazada
where the distributer is under the cap you will see a blck box with wires(about 5 or 6 un plug it un screw it and replace it ( it controld the spark from the plugs to the engine
7/31/2011 11:13:32 PM •
1994 Mazda 626
•
Answered
on Jul 31, 2011
•
208 views
When i drive my car
Hi there!
Its usually happens when the brake pad are tight on the disk which makes the them touching all the time and the pads are supposed to touch the disk only when your push the brakes.
7/22/2011 9:09:29 PM •
1994 Mazda 626
•
Answered
on Jul 22, 2011
•
101 views
Not finding what you are looking for?