1990 Mazda 626 - Answered Questions & Fixed issues

can I put a power steering pump on a 1988 Mazda pickup truck B2200

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

Check the throttle position senser

I assume you are attempting to take the rear brake drum off- if so take the wheel off of course, and tap the drum with a rubber mallet(or hammer-at own risk)- to break the drum away, some times brake drums will have one or two holes on the face, you'll be looking at the drum and see them, find a bolt that fits in the hole or holes and tighten them into the drum, it should push the drum off the shoes, be sure to pay attention to how the shoes come off take a picture of them before breaking them down its a good reference.

Check the print on the demister isn't damaged check fuse

Have you checked for spark? have you pulled a plug after cranking to see if it is wet? does the engine sound like it is turning over faster than usual? did it just not start or did it stall. Did this happen after you changed the spark plugs? I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Usually you pull the fuel pump fuse or relay and start the engine. When it stops running the fuel pressure is lower than 10psi.

yes and no. the part store has some stuff to use. one is called JB WELD. it has 2 tubes .you have to mix it toogether

you can run 89 octane without any issues, no need to run the premium unless it states it in the manual or on the dash.

Don't know of one on your car.Is the pump not running ?

Compruebe los fusibles debajo del tablero

you can take your car to the near garage, or you can DIY to check your car, the Multi-Diag Access J2534 Diagnosis of cooling electronicReading settings cooling circuit, Test servo actuators

1990 auto box problems ? then iam afraid its about time you pensioned it off to the big motorway in the sky as iits well past its sellby date and parts availability

Do you have spark? Do you have fuel ?

check the timing belt, if its ok, then check distributor

Hi Bullock,Did you find a solution for the no spark condition yet?Csaba

UNDER THE BACK SEAT. LIFT UP THE BOTTOM BACK SEAT AND IT IT RIGHT THERE.

no gas

Hi, the signal from the distributor goes thru the computer and then back to the coil. What I recommend is to check the continuity of the wires from the distributor to the computer and then from the computer to the coil. The computer is in the center console under the radio, etc.

You shouldnt need a wiring diagram. The ignition switch should just unplug and and your new one should plug in.